Twin Eagles Teppanyaki Griddle LP to NG Conversion User Manual
TWIN EAGLES
WARNING: BEFORE WORKING ON THIS APPLIANCE DISCONNECT
!
GAS AND ELECTRICAL SUPPLIES.
WARNING: INSTALLATION/GAS CONVERSION MUST BE PERFORMED
!
BY A QUALIFIED TECHNICIAN.
T
EPPANYAKI GRIDDLE
GAS CONVERSION KIT FROM LP TO NG
PN: CKNG-TETG
FOR MODELS: TETG
FOR YOUR RECORDS
IMPORTANT: Retain original proof of purchase to establish warranty period.
Please record the following information and refer to this information when
contacting the company or an authorized service agent. This information is
found on the rating/data plate located on the inside wall of the left side Panel.
Serial No. of Teppanyaki Griddle:
_____________________________________________________________
Date of Natural Gas Conversion:
_____________________________________________________________
Natural Gas Conversion by:
_____________________________________________________________
P/N 18634A 04/11
1. Check to make sure that you have the NG Gas Conversion Kit as follows:
a. PN 15303, Regulator, Natural Gas (1 pc)
b. PN 15110-45, Orifice #45 (2 pcs)
c. PN: 18351, Label, Conversion, Gas (1 pc)
2. Griddle Plate Conversion
2-1) Remove the grease pan from the front of the Griddle Plate Assembly.
2-2) Remove the screws, located in the front of the Griddle Plate Assembly, as shown.
2-3) Raise the front of Griddle Plate Assembly and make sure the rear portion is resting
on the Griddle Top as shown in the left picture. Pull out the Thermostat Bulb so that you
may remove the Griddle Plate Assembly completely, as shown in the right picture.
2-4) Unscrew the nut used to hold the U-Burner from the back and remove the UBurner.
2-5) Replace the orifices #55, used for LP, and replace it with orifice #45, used for
NG. Use a 1/2" Deep Socket and a Socket Wrench to remove and replace the orifice.
Replace Griddle Plate Assembly when finished and re-install the Thermostat Bulb.
2-6) Remove the LP Hose and Regulator Assembly from the coupling, and remove
the 3/8 Flare x 1/2” FIP coupling by turning the coupling counter-clockwise
2-7) Install the factory supplied Natural Gas regulator directly and use pipe sealant
approved for natural gas connection (shown below). Warning: The Natural Gas
Regulator is set at 4” of Water Column.
1
Loading...