Twin Eagles TEGB30B Installation Manual

TWIN EAGLES GRILL BASE

BASE ASSEMBLY &

GRILL HEAD INSTALLATION

TEGB30SD-B Grill Base shown.

TEGB36-B

TEGB42SD-B

Model: TEGB30-B

TEGB30SD-B
TEGB36SD-B

P/N: 18542C 03/08

ASSEMBLY INSTRUCTIONS –TWIN EAGLES GRILL BASE

1. Install casters w/ brakes (A) at the front of the
base and casters w/ out brakes (B) at the
rear and secure them with nuts (C).

(A)

2. Install shelf brackets (D) and (E) securing them
with screws (F) and side shelves.

(D)

( I )

(C)

(B)

3. Remove hex-head screws (G) and flat­washer (H) using a 5/16” wrench and place

the grill head into the cart.

(H)

(G)

(H)

(G)

(F)

(E)

( I )

4. Install the hex-head screws (G) with flat-washer

(H) back into place by initially hand tightening

them. Then use the 5/16” wrench to tighten the
screws completely.

5. Fasten the BBQ grill at the top-rear corners using

the Philip screws (I), reference picture no.2.

(A) Caster w/ brake

(Qty. 2)

(C) ¼”-20 hex nut (Qty. 16)

(B) Caster (Qty. 2)

(D) Shelf Bracket

(LEFT) (Qty. 2)

(F) Flat head screws (Qty. 8)

(E) Shelf Bracket
(RIGHT) (Qty. 2)

(G) Hex-head Philips

screw (pre-installed w/

washers) (Qty. 2)

(H) Flat-washer

(pre-installed w/

hex-screw) (Qty. 2)

(I) 10-32 x ½”
Phillips Screw

(Qty. 2)

1