TVILIGHT CitySense Plus Installation Manual

CitySense Plus

Installation Manual

Cable Gland

English

Page 2 of 10

Version Author Date Changes Approved by

v4 Henri Eskonen 21/12/2017 Added version

control page. Minor
formatting.

v4 - 21/12/2017

TVILIGHT BV / Westerhaven 13, 9718 AW Groningen, the Netherlands
[phone] / [e-mail] / www.tvilight.com

Page 3 of 10

In order to function properly, CitySense Plus must be
connected to a dimmable driver/ballast.

NOTE: Some dimmable drivers/ballasts must be
programmed/set to dimmable mode. If this has not been
done, CitySense Plus will not be able to dim the connected
armature.

ATTENTION:

Page 4 of 10

In box:

5m Cable

M16 Cable Gland Sticker

Generic Strap x 2

You’ll need:

Max = 11mm

Min = 8mm

M16 ThreadDrill

Wago x 4

TVILIGHT

www.tvilight.com

TVI-CSP1-01-0014

Page 5 of 10

1. Push cable gland through wire

2. Drill M16 threaded hole into pole

5m

Note: for added protection against rust, the use of an anti-corrosion

spray such as WD40 Corrosion inhibitor or equal is recommended.

Page 6 of 10

3. Run wire through hole

4. Screw cable gland in hole

Rotate the cable gland to tighten

Twist the end leads

of the wires

Page 7 of 10

5. Strap product to pole

6. Level the product

* Ensure Tensioning Tool is set
to maximum tension (#4)

Tensioning Tool

Position 2: Standard

1
2
3