Tuzio E7023, E7024 User Manual

Tuzio® Milano
Towel Warmer

Installation Guide

Code: E7023 / E7024

23.5” x 31” Electric Plug-In

Technical Helpline:
Toll-Free 1-877-757-8990
www.icocanada.com

Towel Warmer Installation Procedure

1. A 110V receptacle located no further than 18” from electric plug-in exit location on towel warmer (see fig. 2), and not
above electric plug-in exit location.

2. Wall studs or plywood backing is required in the wall at all bracket locations. See figure 2 for bracket locations.

Rough-in Requirements (see figure 3)

1

Do not connect the Towel Warmer to the power supply until all instructions have been read and installation carried out in
accord with them. The heating element is 150W 110V. The element conforms to UL standards and the unit to CSA
standards (File ref: 229718). Ensure the CSA label is visible.

1. Turn off power supply.

2. Plug connector in.

3. Switch on power supply again.

Warning: In case of damage or failure of the Towel Warmer the unit should be returned to the
manufacturer or their distributor. The warranty of 1 year on the heating element and 5 years
on the Towel Warmer is NOT VALID in case of improper use or installation. Product is
designed for use within Canada and the United States only.

Installation Instructions (see figure 1)

2

1. Check all items have been received. You should have Towel Warmer and mounting bracket kit. Read all instructions
before continuing.

2. Fix wall supports "B" including collar “A” to the wall using the screws provided and in locations as shown on figure 2.

3. Screw the threaded pin "C", into the threaded bushing “D”.

4. Hang and adjust the Towel Warmer using set screws "E" to lock pin "C" in the wall bracket "B". Ensure the Towel
Warmer is firmly and safely fixed.

Electric Plug-In Connection

3

fig. 1