Turnstone TS345B User Manual

Page 1 of 2

TS345B Rev B

TS345B

R

©

2001 Steelcase Inc.

Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.

1. Finger tighten the 2 bolts with washers into the

crossrail between the side rails as shown.

(NOTE: There is a nail on each end of the
crossrail to stabilize the crossrail. Please
handle it with care.)

2. Place the seat between the side frames, over

the crossrail. Finger tighten the 2 bolts with
washers into the sides of the seat, as shown.

TS345-03

NOTE: Put the washers
on the bolts, before you
assemble the chair.

Backrest

Seat

CR

Page 2 of 2

TS345B Rev B

3.  Finger tighten the other 2 bolts

with washers into the sides of
the seat, as shown.

5.  Rotate backrest to upright

position, as shown. Finger
tighten the other two bolts
with washers into the sides
of the backrest, as shown.
Place the chair on a flat level
surface. Firmly tighten all bolts
with the supplied Allen Wrench.

4. Place backrest in a forward leaning position,

as shown. Finger tighten 2 bolts with washer
through the side frame into the backrest
as shown.