Turnigy 2S/3S, 2S, 3S User Manual

Turnigy 2S/3S Lithium Polymer Battery Charger

User Manual

1. D

2.0 F

3.0 E

ESCRIPTION

1.1 Before using the Turnigy 2S/3S
Lithium Polymer (LiPO, Li-Po) battery
charger you must read this manual. It is
important to understand its operation and
all safety steps before

EATURES

using it.

2.1 The charger’s power input requires
11V to 14V DC power. Higher or reversed
voltages will cause permanent damage and
will void the warranty.

2.2 There are two LED status lights. The red light indicates that
power is connected to the charger. The green light means that
charging is in progress. The green light goes out when charging is
complete.

LECTRICAL SPECIFICATIONS

3.1 Input Voltage: 11V-14VDC at l.2A. A voltage regulated 11V-l4V
DC supply may be used. Or a 12VDC automotive battery (rated at 15
AH or higher).

3.2 Output voltage:
2S operation: 8.4 VDC
3S operation: 12.6 VDC

3.3 Output Current: 800 mA typical

3.4 Output Balance Accuracy: 20mV typical

3.5 The red alligator lead is the Positive power input, and the

Black alligator is negative input. Do NOT connect the power leads
backwards (reverse voltage). This will damage the charger and void
the warranty.

4.0 C

HARGING PROTECTION

4.1 Microprocessor based real-time monitoring techniques use

precise calculations to ensure a full battery charge indication. It
helps to ensures safe and reliable recharge control, which extends
battery life.

4.2 The fully charged battery voltage difference, between the

individual cells, is typically less than 20mV. Charging cut-off
voltage is between 4.18V to 4.20V.

4.3 The charger automatically detects if the battery pack is two

(2S) or three (3S) series-connected cells. There is a cable port
connection dedicated for 2S packs and another one for 3S packs. Do
not charge more than one pack at a time. DO NOT install two packs!

Copyright 2009 Page 1 Feb-15-2009

5.0 A

TTENTION

5.1 Never leave the charger unattended. If you will be away from

the charger then do leave it connected it to the battery. EVER.

5.2 Charge all batteries on concrete, at least 10 feet (3 meters)

away from combustible materials.

5.3 Do not use if flammable liquids are in the area.

5.4 Use this charger only with compatible Lithium Polymer battery

packs. No other battery chemistry can be used.

5.5 Do not charge batteries that are hot. Allow them to cool first.

5.6 Do not charge any battery that appears to be swollen or damaged

in any way.

5.7 Do not disassemble the charger in any way. This is dangerous

and will void the warranty.

5.8 Keep the charger away from children and animals.

5.9 Do not connect more than one battery pack a time.

Please see the additional information on the next page.

Copyright 2009 Page 2 Feb-15-2009