Turner Hastings Close Coupled Toilet Installation Instructions Manual

INSTRUCT236
REV180917 A/MM

Close Coupled Toilet

Lever Instructions Installation Instructions

Important Information:

Please check the products for transport damage and that contents are complete
before installation.
Consult a qualified plumber if you have any problems installing this product.
Complaints made following installation regarding the above cannot be accepted.

Installation Guide

Geberit Bottom Inlet Valve

CL

W

L

Installation Guide - TOILET FITTING INSTRUCTIONS

Please read this document prior to installation of your product.
Upon receiving your product please open all cartons carefully and inspect for any
manufacturing defects.This installation guide and the fixings provided are intended for fixing into a
solid floor. If you are installing this product into a non solid floor please amend your installation
techniques and fixings accordingly.

Tools required for installation

Hand Held

Drill

Safety

Goggles

Spirit Level Tape

Measure

Pencil Adjustable

wrench

Silicon GunPTFE Tape

1. Valve in tank

Valves are pre-installed into tank prior to delivery.The flexible cable should always be allowed
to bend gently without sharp changes in geometry.

CL

W

L

Installation Guide

2. How to install a lever

Please ensure that your cistern has the water inlet and flush valve installed.
Insert nylon sleeve into cistern hole. Secure from the rear using metal plate, washers and
back nut. Ensure back nut is fastened tightly to avoid handle coming loose. The hole in the
cistern may be in the front or the side.

Installation Guide

3. Installing a close-coupled toilet

Carefully measure and plumb in all necessary pipework prior to installing
the toilet. Ensure that you have a clear space within which to work.
Ensure that the installation of flush and filling valve is complete as instructed,
and that all fittings are tested and in working order.
Insert the cistern bolts and locate the cistern correctly onto the pan as
shown below. Once correctly positioned tighten wing nuts to ensure a
secure connection to the WC pan.
Once the cistern is secured to the pan offer the toilet up to the desired position.
Ensure that the cistern sits flat against the wall and is level and the foot of the pan is
perpendicular to the wall using a pencil to mark around the foot of the
pan and the fixing holes in both foot and cistern.

Bolt
Rubber Washer
Foam Washer
Metal Washer
Nut

Cistern
M6 Nut
Coupling Plate
Backnut
Rubber Sealing Washer
WC Pan
Leather Washer
Metal Washer
Wing Nut