Turner BMW E46 Non-M Skid Plate Installation Manual
BMW E46 Non-M Skid Plate Installation Instructions
Introducing the new Turner E46 Non-M Skid Plate! The Turner engineering team set out to design a nocompromise belly pan replacement which requires no modification to the vehicle, and offers some serious
protection for the bottom of your vehicle! The finished product was this; the ultimate upgrade for your belly
pan replacement woes, all for nearly the same cost as the plastic OEM replacement.
Our heavy duty aluminum skid plate features vehicle specific mounting braces which bolt right up to existing
mounting points in the chassis.
Installation of the kit can be done easily in a driveway if needed, and we've included everything you need to
make this a fast and easy upgrade.
Installation time: 1 hour
Proper service and repair procedures are vital to the safe, reliable operation of all motor vehicles as well as the personal safety of those performing the
repairs. Standard safety procedures and precautions (including use of safety goggles and proper tools and equipment) should be followed at all times
to eliminate the possibility of personal injury or improper service which could damage the vehicle or compromise its safety.
BMW E46 NON-M SKID PLATE INSTALLATION INSTRUCTIONS
Installing the New Skid Plate Kit
T#637731T#637729
Step 1
Step 2
Step 3
Step 1
• Safely lift and support the vehicle. We recommend removing the front wheels for better access.
• Remove the center insulation panel and lower fender liners Step 1 photo.
• Remove the ducts from each fenderwell LH shown in Step 2 photo.
• Remove the inlet ducts from the front bumper cover LH shown in Step 3 photo.
- A long Phillips head screwdriver works well for this step.
FRONT OF VEHICLE
Center OEM insulation panel
(not shown)
RH lower
fender liner
Step 2 Step 3
LH lower
fender liner
FRONT OF VEHICLE FRONT OF VEHICLE
© 2020 TURNER MOTORSPORT 16 SOUTH HUNT RD. AMESBURY, MA 01913 1.800.280.6966 WWW.TURNERMOTORSPORT.COM PAGE 2 OF 6
Loading...