Turck TBPN-L1-FDIO1-2IOL Data Sheet

Compact PROFIsafe / PROFINET Block I/O Module
Safe Digital Inputs and Outputs, Standard Universal Digital Channels, IO-Link
Master Ports
TBPN-L1-FDIO1-2IOL

■ PROFINET slave

■ Integrated Ethernet switch

■ 100 Mbps supported

■ 2 x M12, 4-pin, D-coded, Ethernet field-

bus connection

■ 7/8" connector for power supply, 5-pin

■ Two safe digital SIL3-inputs

■ 2 IO-Link Master V1.1 slots

■ Compact PROFINET PROFIsafe block I/

O module

■ 5-pin power supply

■ 2 safe digital inputs

■ 2 safe universal digital inputs or out-

Type designation TBPN-L1-FDIO1-2IOL

Ident-No. 6814053

Supply

Supply voltage 24 VDC
Admissible range 20.4…28.8 VDC
Voltage supply connection 5-pin male 7/8" connector X1
Electrical isolation galvanic isolation of the voltage groups V1 and V2,

voltages up to 500 VAC

puts

■ 4 universal digital inputs or outputs

■ 2 IO-Link Master Ports Class A

■ Glass-fiber reinforced housing

■ Shock and vibration tested

■ Fully potted module electronics

■ Protection classes IP65 / IP67 / IP69K

System data

Fieldbus transmission rate 100 Mbps
Fieldbus connection technology 2 x M12, 4-pin, D-coded
Web server integrated
Service interface Ethernet via P1 or P2

PROFINET

Addressing DCP
Conformance class B (RT)
MinCycleTime 1 ms
Diagnostics acc. to PROFINET alarm handling
Topology detection supported
Automatic addressing supported
Media Redundancy Protocol (MRP) supported

Safety Data

PL acc. to DIN EN 13849-1:2008 e
Category acc. to DIN EN 13849-1:2008 4
SIL according IEC 61508 3
Useful Lifetime 20 Jahre (EN ISO 13849-1)

Safety Inputs OSSD

Low level signal voltage EN 61131-2 Type 1 ( < 5 V; < 0.5 mA)
High level signal voltage EN 61131-2 Type 1 ( > 15 V; > 2 mA)
Max. OSSD supply per channel 2 A per C0, C1, C2, C3,

1.5 A at 70 °C

please consider derating as shown in Figure 1
Max. tolerance test pulse width 1 ms
Interval between 2 test pulses, minimum 20 ms at 1 ms test pulse width

15 ms at 0.5 ms test pulse width

Figure 1

Figure 2

Edition • 2019-01-21T19:17:30+01:00

1 / 7 TURCK Inc.

Compact PROFIsafe / PROFINET Block I/O Module
Safe Digital Inputs and Outputs, Standard Universal Digital Channels, IO-Link
Master Ports
TBPN-L1-FDIO1-2IOL

Safety Inputs floating/antivalent

Max. loop resistance
Max. cable length

Test pulse, typical 0.6 ms
Test pulse, maximum 0.8 ms
Sensor supply Versorgung V AUX1/T1 max. 2 A

Interval between 2 test pulses, minimum 900 ms
Additional information no connection to external potential allowed

Safety Outputs

Output current in off state < 5 V
Output current in off state < 1 mA

Test pulse, typical 0.5 ms
Test pulse, maximum 1.25 ms
Interval between 2 test pulses, typical 500 ms
Interval between 2 test pulses, minimum 250 ms
Actuator power supply Versorgung V AUX1/T1 max. 2 A

Max. output current 2 A (resistive)

Additional information The load must be mechanically or electrically inert to

< 150 ò

max. 1 uF at 150 ò

, limited by cable capacitance

, please consider derating as shown in Figure 1

, suitable for inputs according to EN 61131-2 Type 1

, please consider derating as shown in Figure 1

, 1 A (inductive)

tolerate the test pulses.

When configured as a PPM switching output the

negative pole of the load should be wired to the M-

terminal of the corresponding output (Pin 2).

Digital inputs

Connectivity inputs M12, 5-pin
Input type PNP
Switching threshold EN 61131-2 Typ 3, PNP
Low level signal voltage < 5 V
High level signal voltage > 11 V
Low level signal current < 1.5 mA
High level signal current > 2 mA
Input delay 2.5 ms
Sensor supply C4, C5: FSO0 max. 2 A; 500 mA per input

C6: V AUX1 max. 2 A

C7: FSO1 max. 2 A

, please consider derating as shown in Figure 1
Electrical isolation galvanic isolation to P1/P2

, voltages up to 500 VDC

Connectivity outputs M12, 5-pol
Output current per channel 0.5 A, short-circuit-proof,

max. 2 A (resistive)/1 A (inductive) all outputs
Actuator power supply C4, C5: FSO0 max. 2 A; 500 mA per input

C6: V AUX1 max. 2 A

C7: FSO1 max. 2 A

, please consider derating as shown in Figure 1

IO-Link

Number of channels 2
IO-Link specification Version 1.1
IO-Link port type Class A and Class B
Frame type supports all specified frame types
Supported devices max. 32 byte input/32 byte output
Transmission rate 4.8 kbps (COM 1) / 38.4 kbps (COM 2) / 230 kbps

(COM 3)
Power supply Versorgung V AUX1/T1 max. 2 A

, please consider derating as shown in Figure 1

Edition • 2019-01-21T19:17:30+01:00

2 / 7 TURCK Inc.

Compact PROFIsafe / PROFINET Block I/O Module
Safe Digital Inputs and Outputs, Standard Universal Digital Channels, IO-Link
Master Ports
TBPN-L1-FDIO1-2IOL

Standard/Directive conformity

Vibration test acceleration to 20 g

acc. to EN 60068-2-6
Shock test acc. to EN 60068-2-27
Drop and topple acc. to EN 60068-2-31/IEC 60068-2-32
Electromagnetic compatibility acc. to EN 61131-2
Approvals and certificates CE, FCC
UL Certificate cULus LISTED 21 W2, Encl.Type 1 IND.CONT.EQ.

General Information

Dimensions (W x L x H) 60.4 x 230.4 x 39mm
Operating temperature -40…+70 °C
Storage temperature -40…+85 °C
Altitude max. 5000 m
Protection class IP65

IP67

IP69K
Housing material PA6-GF30
Housing color Black
Window material Lexan
Material screw 303 stainless steel
Material label Polycarbonate
Halogen-free yes
Mounting 2 mounting holes � 6.3 mm

The data sheet serves as advance information. For

definitive values see the corresponding product

manual. In this respect, no liability for completeness

and accuracy can be applied to the content of this

data sheet.

Edition • 2019-01-21T19:17:30+01:00

3 / 7 TURCK Inc.