Turck PS250R-609-LUUPN8X-H1141 Data Sheet

Pressure transmitter (front-flush)
with voltage output and PNP/NPN transistor switching output
PS250R-609-LUUPN8X-H1141

Type code PS250R-609-LUUPN8X-H1141

Ident no. 6833038

Relative pressure 0…250bar rel.
Operating range 0…3626psi
Operating range 0…25MPa
Admissible overpressure
Burst pressure
Response time < 3 ms

Power supply

Operating voltage 18…30VDC
Current consumption
Voltage drop at I
Protective measure SELV; PELV according to EN 50178
Short-circuit/reverse polarity protection yes/ yes
Protection type and class IP67/ III

Outputs

Output 1 switching output or IO-Link mode
Output 2 analog output

e

ð 625 bar
ï 1200 bar

ð 50 mA
ð 2 V

■

Front-flush mounted diaphragm

■

Reading of adjusted values without
tools

■

Secure programming through recessed
pushbutton and keylock

■

Permanent indication of pressure (bar,
psi, kPa, MPa…)

■

Peak pressure memory

■

Pressure range 0 … 250 bar rel.

Wiring diagram

Functional principle

The pressure sensors of the PS series oper­ate with piezo-resistive ceramic measuring
cells. The ceramic diaphragm is unbalanced
in proportion to the pressure applied. Depend­ing on the sensor type, the voltage produced
is made available either as switching or ana­log output signal. Non-rotatable and rotatable
sensors, numerous thread types, front-flush or
dead-zone free diaphragms and an accuracy
of 0.5% of full scale guarantee highest flexibili­ty and safe process interfacing.

Switching output

Output function NO/NC , PNP/NPN
Accuracy switching output ± 0.5 % v. E. BSL
Rated operational current 0.2 A
Switching frequency
Switching point distance
Switch point: (min + 0.005 x range) up to 100% f.s.
Release point(s) min up to (SP - 0.005 x range)
Switching cycles

Analogue output

Voltage output
Operating range 0…10 V, 0…5 V (3-wire)
Load
Accuracy LHR analog output ± 0.5 % of final value BSL

IO-Link

Communication specified acc. to version 1.0
Programming FDT / DTM
Transmission physics corresponds to 3-wire physics (PHY2)
Transmission rate COM 2 / 38.4 kbps
Process data width 16 bit
Measured value information 14 bit
Switchpoint information 2 bit
Frame type 2.2
Genauigkeit ± 0.5 % of final value BSL

Edition • 2015-02-13T19:36:28+01:00

1 / 3 Hans Turck GmbH & Co.KG ñ D-45472 Mülheim an der Ruhr ñ Witzlebenstraße 7 ñ Tel. [phone] ñ Fax [phone] ñ [e-mail] ñ www.turck.com

ð 180 Hz
ï 0.5 %

ï 100 mil.

ï0…ð10VDC

ï 2 kò

Pressure transmitter (front-flush)
with voltage output and PNP/NPN transistor switching output
PS250R-609-LUUPN8X-H1141

Temperature behaviour

Medium temperature -10…85 °C
Temperature coefficient zero point T
Temperature coefficient span T

Ambient conditions

Ambient temperature -40…80 °C
Storage temperature -40…+80°C
Vibration resistance 20 g (9…2000 Hz), according to IEC 68-2-6
Shock resistance 50 g (11 ms) , according to IEC 61508
EMC EN 61000-4-2 ESD:4 kV CD / 8 kV AD

Housing

Housing material stainless-steel/plastic, V2A (1.4305)
material pressure connection stainless steel A4 1.4435 (AISI 316L)
Sealing material FPM spez.
Process connection G ½″ front-flush
Wrench size pressure connection / coupling nut 30
Connection male, M12 x 1

k0

kS

± 0.15 % of full scale / 10 K
± 0.15 % of full scale / 10 K

EN 61000-4-3 HF radiated: 15 V/m
EN 61000-4-4 Burst: 2 kV
EN 61000-4-5 Surge: 1000 V, 42 Ohm
EN 61000-4-6 HF cable bound: 10 V

Reference conditions acc. to IEC 61298-1

temperature 15…25 °C
Atmospheric pressure 860…1060 hPa abs.
Humidity 45…75 % rel.
Auxiliary power 24 VDC

Display 4-digit 7-segment display, rotatable by 180°, disen-

gageable
Switching state LED yellow
Programming options start/end value analog output; switch/release point;

PNP/NPN; NO/NC contact; hysteresis/window

mode; damping; pressure unit; peak pressure mem-

ory
Unit display 5 x LEDs green (bar, psi, kPa, MPa, misc)

Edition • 2015-02-13T19:36:28+01:00

2 / 3 Hans Turck GmbH & Co.KG ñ D-45472 Mülheim an der Ruhr ñ Witzlebenstraße 7 ñ Tel. [phone] ñ Fax [phone] ñ [e-mail] ñ www.turck.com