Turck FDNL-CPG88-T-V Data Sheet

FDNL-CPG88-T-V

This station provides eight inputs and eight outputs. The input and
output circuits are combined in one connector. The unit is specifically designed
to work I/O devices that have both an input and output.

Each connector has both input LED and ouput LED associated with it. The
LED turns green if the I/O point is on. The LED turns red if the I/O point is
shorted. The input LED turns amber if an open circuit between V+ and V- is
detected. The output LED turns amber if there is open circuit between Output
and V-. Open circuit detection must be enabled using a software configuration
tool.

The node address can be set using the rotary switches located under the
device cover or through software node commissioning. The unit automatically
detects the communication rate.

The FDNL-CPG88-T-V supports explicit messaging, poll, change of state, and
cyclic I/O messages. These connections are established through UCMM or
predefined master/slave connection set.

Dimensions

FDNL-CPG88-T-V

•

Advanced DeviceNet™ Station

•

Eight Combined Input and Output Points

Applications

•

For Wet or Dry Environments

•

For Use With Part Vertification
Arrays, Three-Wire sensors,
or Discrete Actuators

Features

•

PNP Short-Circuit Protected Inputs
with Open-Circuit Protection

•

0.5 Amp Short-Ciruit Protected Outputs
with Open-Circuit Protection

•

Rotary Address Switches

TURCK Inc. 10240449 Rev 1.0 06/07

FDNL-CPG88-T-V

Connectors

DeviceNet™

Style: 5-Pin minifast ®
Cordset: Bus Line use RSM RKM 579-*M
Tee: Bus Line use RSM 2RKM 57

Combined Input/Output Connectors

Type ‘C’

Style: 5-Pin eurofast

Cordset: Single Sensors, Outputs or Push Buttons

use RK 4.4T-*-RS 4.4T

Splitter: Part Verification Array use
VB2-RK 4.4T 1/2RK 4.4T-*/*S651

®

1 = V+
2 = Output Signal
3 = GND
4 = Input Signal
5 = PE

1 = Shield
2 = V +
3 = V –
4 = CAN_H
5 = CAN_L

Male Female

Through Bus

Input/Output Connectors

I/O Data Mapping

Item Number: F2014
Product Code: 7/1329 (531 hex)

Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0

Input

Data

Output

Data

Output

Data

TURCK Inc. 10240449 Rev 1.0 06/07

0 I-7 I-6 I-5 I-4 I-3 I-2 I-1 I-0

1 ISS-7 ISS-6 ISS-5 ISS-4 ISS-3 ISS-2 ISS-1 ISS-0

2 IOS-7 IOS-6 IOS-5 IOS-4 IOS-3 IOS-2 IOS-1 IOS-0

3 OS-7 OS-6 OS-5 OS-4 OS-3 OS-2 OS-1 OS-0

4 APS

Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0

0 O-7 O-6 O-5 O-4 O-3 O-2 O-1 O-0

Abbreviations

I = Input Data (0=OFF, 1=ON)

O = Output Data (0=OFF, 1=ON)

ISS = Input short Status (0=Working, 1=Fault)

OS = Output Status (0=Working, 1=Fault)

IOS = Input Open Status (0=Working, 1=Fault)

OGS = Output Group Status (0=Working, 1=Fault)

IGS = Input Group Status (0=Working, 1=Fault)

APS = Aux Power Status (0=OFF, 1=ON)