USER’S MANUAL
1
Model:TDH17008L TURBO MIRA Electric Kettle
Electrical parameter
Voltage : 220-240V AC Power : 2500-3000W Frequency : 50/60Hz
Features of product
Rating Capacity：1.7L
Components : Body and Power Base
1. Steel body and limpidity water gauge.
2. There is an auto cut-out device in the kettle. It will shut off the power supply after the water
is boiling; and the light will be turned off.
3. There is an overheating protector in the kettle. In the event of overheating, such as
operating without water in the kettle or the water being boil-dry, the kettle will be
automatically shut down to prevent further damage.
4. The net can wash after taking down.
5. Cord storage with anti-pull feature,when pull the power cord, be care on it to avoid damage
it.
IMPORTANT SAFEGUARDS
1. When using electrical appliance ，the following basic safety precautions should always be
followed：
2. Read all instructions before using.
3. Before connecting the kettle to the power supply, check that the voltage indicated on the
appliance corresponds with the voltage in your home. If this is not the case, contact your
dealer and DO NOT use the kettle.
4. This kettle just can use with the attach power base, mustn`t use it with other sets.
2
5. If the supply cord or any part is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
6. Unplug from outlet when not in use or pouring water in the vessel.
7. Do not hang the power cord on the edge of table or touch the appearance with high
temperature, to avoid damage the power cord.
8. Place the appliance on the flat surface. Do not place on the heated surface or near a hot
gas or electric burner or in a heated oven.
9. Please do not boil when lack of water, it is easy to damage the heating plate. During the
period of using, if the water is so few or drying in careless, should unplug immediately then
cooling for 15 minute.
10. Ensure that the kettle is used on a firm and flat surface where the children can’t touch.
11. To protect against electric shock, do not immerse cord、plug、power base and kettle in water
or other liquid.
12. After boiling, please do not touches the steams from spout do not open the cover in a hurry
too, to avoid hurt by steam.
13. When pouring, be careful in order to protect your self.
14. Before cooling, if you need refill, please be careful when open the cover.
15. When using, please far from the children, so can prevent them pull the power cord or knock
the body and happen accident.
16. This product just for boiling water, except for boil coffee, tea, wine or other chemical matter.
17. Do not touch the appearance of high temperature, but the handle and the switch button is
safe.
18. The kettle is for household use only, not for outdoor.
19. When move the kettle with full boiling water, please be careful, to avoid any hurting.
20. Do not let children play this product, when using, please look after children to prevent
hurting happen.
21. The use of accessory attachments, which are not recommended by the appliance
manufacturer, may result in fire, electric shock or personal injury.
22. When washing or out of using, please unplug. Must be cooling when washing or change
parts.
23. Boiling for need to save energy.
24. When boiling, please sure cover well, so the steam can not burst through the cover when
boiling, and to avoid wasting the energy.
25. After boiling, mustn’t press the button to “I” with force, to avoid the waste, at the same time
will damage the steam switch.
26. When using, can not put the power base on the metallic plate or metallic appearance.
27. If the kettle is overfilled, boiling water may be ejected.
28. The kettle is only to be used with the stand provided.
29. Save these instructions.
3
OPERATION
1. It is recommended that operate the kettle several times following the below instruction and
discard off the water before first use. This will remove the material or dust remained in the
appliance which is caused by the manufacturing process.
2. Open the lid by turning the Lid up while pressing the Lid lock and fill water into the kettle.
Then replace the lid otherwise the kettle could not be cut off power automatically after
water being boiled.
3. Caution: the filled water level must be between the “1.7L” and “0.7L” level as indicated on
the housing. Too less water will do damage to the heat element and if the water is
overfilled, boiling water may be ejected.
4. Replace the kettle on the Power Base and connect to power supply. Position the kettle so
that the spout of kettle is facing away from you.
5. Press the switch to “I” position and the lamp will be illuminated. And water begins to be
heated up. Do not remove the lid while the water is boiling.
6. Power will be cut off automatically and switch will be back to “0” position once water has
been boiled. And the lamp will be off.
7. The boiling process can be terminated at any time by lifting the kettle off the Power Base.
CAUTION :
1. Never operate the appliance empty. In the event of this case occurred, the thermal cut-off
inside the kettle would operate to cut off power automatically. Unplug the appliance and let
it completely cool down.
2. The filter must be in place during operation otherwise water spillage may occur.
Cleaning & Maintenance
1. Remove the plug from wall outlet and let the appliance completely cool down before
cleaning.
2. Do not immerse power cord, kettle and Power Base in water.
3. In order to maintain the polish of the outer surface, do not use abrasive cleaner to wipe the
housing.
4. Periodical descaling is needed. The interval of descaling depends on the hardness of water
in your living area and the frequency your using the kettle.
5. The Filter can be detached for easier cleaning simply by pulling it out. To attach, insert the
Filter into the support dent.
6. The power cord can be rounded around the bottom of power base for storage.
7. Do not attempt to dismantle the kettle or power base. No user serviceable parts inside it.
For any problem, contact the authorized service facility for help.
4
Loading...