TURBOCOMM EC420 User Manual

EC420 User’s Manual
Introduction
Important Rules for safe Operation
In addition to the careful attention devoted to quality standards in the manufacture of your
TurboComm DOCSIS Cable modem, safety is a major factor in the design of every product.
However, safety is your responsibility, too.
TurboComm Cable Modem and accessory equipment. Please read them carefully before operating
and using your modem.
Installation
Read and Follow Instructions
You should read all the safety and operating instructions before operating the modem. Follow all
operating instructions.
Retain Instructions
You should save all the safety and operating instructions, for your future reference.
Heed Warnings
Comply with all warnings on the products and in the operating instructions.
Check Power Sources
Operate this product only from the type of power source indicated on the product’s marking label. If
you are not sure of the type of power supplied to your home, consult your dealer or local power
company.
Be Careful of Overloading
Do not overload wall outlets or extension cords, as this can result in a risk of fire or electric shock.
Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation,
and broken plugs are dangerous. They may result in a shock or fire hazard, Periodically examine the
cord, and if its appearance indicated damage or deteriorated insulation, have it replaced by your
service technician.
Protect Power Cords
Route power supply cords so that they are not likely to walked on or pinched by items placed upon
or against them. Pay particular attention to cords where they are attached to plugs and convenience
receptacles, and examine the point where they exit from the product.
Check Ventilation
Slots and openings in the enclosure are provided for ventilation to ensure reliable operation of the
product and to protect it from overheating. Do not block or cover these openings. Never block these
openings by placing the product on a bed, sofa, rug, or other similar surface. Never place this prodct
near or over a radiator or heat register, or any other heat source (including amplifiers). Do not place
this product in a built-in installation, such as a bookcase or equipment rack, unless you provide
proper ventilation.
Do Not Use Accessories
Do not use attachments, unless they are recommended by TurboComm, as they may cause electrical
or fire hazards,
Use the Recommended AC Adaptor
You must use the adaptor that comes with your TurboComm Cable Modem.
Do Not Use Near Water
Do not use this product near water – for example, near a bath tub, wash bowl, kitchen sink or
laundry tub, in a wet basement or near a swimming pool, and the like.
Do Not Place Near High Temperature Source – for example near a steamer, kitchen range fire, and
the like.
Use Caution in Mounting This Product
Do not place this product on an unstable surface or support. The product may fall, causing serious
injury to a child or adult, as well as serious damage to the product.
Loading...
+ 4 hidden pages