Turbo Air TGF-10SD Installation Manual
Turbo Air Speeds up the Pace of Innovation
Super Deluxe Glass Door
Refrigerators & Freezers
Installation and Operation Manual
Please read this manual completely before attempting to install or operate this equipment
REFRIGERATORS
TGM-5SD
TGM-7SD
TGM-10SD
TGM-12SD
TGM-15SD
TGM-20SD
TGM-23SD
TGM-35SD
TGM-47SD
TGM-72SD
FREEZERS
TGF-5SD
TGF-10SD
TGF-15SD
TGF-23SD
TGF-35SD
TGF-47SD
TGF-72SD
www.turboairinc.com
CONTENTS
1. SERIAL NUMBER
PAGE
........................................................................................
2
2. ENERGY STAR
3. INSTALLATION............................................................................................ 3
4. CLEANING
5. BASIC OPERATION
6. TROUBLESHOOTING
7. WARRANTY
............................................................................................
...................................................................................................
................................................................................
...........................................................
.........................................................................................
5~9
11~13
10
SERIAL NUMBER
The serial number can be found on the data label located inside the unit.
Please retain the unit serial number for service purposes.
2
4
ENERGY STAR
As an Energy Star Partner, the following products meet the Energy Star
guidelines for energy efficiency.
TGM-5SD / TGM-7SD / TGM-10SD / TGM-12SD / TGM-20SD / TGM-23SD
TGM-35SD / TGM-47SD / TGM- 72SD
TGF-23SD / TGF-35SD / TGF-47SD / TGF-72SD
2
INSTALLATION
1. GOOD AIR CIRCULATION
- Please make sure to avoid any partition or objects that may stop the air flow
- Please make sure there is enough space for air circulation to the rear of the unit
Recommended space between the rear of the unit to the wall is at least 5 inches
2. PLACE ABOVE STRONG FOUNDATION
- Please make sure that the floor where the unit will be placed can support the total
weight plus any other contents that it may hold
3. DO NOT PLACE NEAR HEAT
- Please make sure to avoid hot corners and locations near stoves
- High ambient temperature will significantly reduce cooling efficiency
4. INDOOR USAGE ONLY
- This unit is designed and tested for indoor use only
- Outdoor usage will void its warranty
5. STABILIZATION
- Turn leg levelers counter-clockwise in order to level the unit properly
6. LEVELING
- Please make sure that the unit levels from the front to the back and side to side
7. UNIT NEEDS TO BE PLUGGED TO A DEDICATED OUTLET
3
CLEANING
1. CLEANING STAINLESS STEEL INTERIOR AND EXTERIOR
: Damage to stainless steel finish due to improper use of cleaning products or
non- recommended products is NOT covered under this product's warranty
• Do
- Use warm, soapy water and a soft, clean cloth or sponge
- Rinse surfaces with clean, warm water and dry immediately to avoid water spots
• DO NOT USE
- Abrasive or harsh cleaners
- Ammonia
- Chlorine bleach
- Concentrated detergents or solvents
- Metal or plastic-textured scouring pads
- Vinegar-based products
- Citrus-based cleaners
2. CLEANING THE CONDENSER FINS
- To maintain proper refrigeration performance, the condenser coil must be free of
dust, dirt, and grease
This will require periodic cleaning. condenser fins should be cleaned at least every
three months (90 days) or as needed
3. CLEAN THE GASKET
- The door gasket should be cleaned frequently to maintain proper sealing
4. CHECK AFTER CLEANING
- Check the unit again for safety
- Check that the unit is operating properly
CAUTION
1. POWER CORD
- Please make sure that the power cord is connected to the proper voltage
- The power cord must be connected to a protected circuit with the correct voltage
and amperage
- Turn ʻoffʼ the power switch before disconnecting the power cord, whenever
performing maintenance functions or cleaning the refrigerated cabinet
- Compressor warranties are void if compressor burns out due to improper voltage
2. RE-STARTING
- If disconnected, wait for 5 minutes before re-starting
4
Loading...