Turbo Air TBC-50SD/SB, TBC-95SD/SB, TBC-50SD, TBC-50SB, TBC-95SD Installation And Operation Manual

Turbo air Speeds Up the Pace of Innovation

Horizontal Bottle Cooler
Installation and Operation Manual

Please read this manual completely before attempting to install or operate this equipment!

Full Stainless Steel Visible Exterior

TBC-50SD, 50SB/ TBC-95SD, 95SB

SD series: Stainless Steel Exterior
SB series: Black Laminated Vinyl Exterior
(This picture shows TBC-50SD in the SD series.)

SPECIFICATIONS

............................................................................................

2

SERIAL NUMBER

............................................................................................

2

INSTALLATION OF THE BOTTOM SHELVES..................................................3

INSTALLATION OF THE DIVIDERS.................................................................4

INSTALLATION OF THE OPENER KIT ............................................................5

HOW TO USE THE BOTTLE OPENER............................................................6

INSTALLATION .................................................................................................7

CLEANING & CAUTION ...................................................................................8

BASIC OPERATION..........................................................................................9

BEFORE REQUESTING SERVICE................................................................10

WARRANTY

.............................................................................................

11~13

Horizontal Bottle Cooler

2

Turbo air

CONTENTS

SPECIFICA TIONS

PAGE

MODEL COMP H.P. V/Hz REFRIGERANT AMPS WEIGHT

TBC-50SD/SB 1/3 1 15V/60Hz R-134a 6.8A 235
TBC-95SD/SB 1/2 1 15V/60Hz R-134a 9.2A 375

The serial number is located on the rating label which is on interior right side
wall.
Please retain the unit’s serial number for service purpose.

SERIAL NUMBER

3

Turbo air

* Note:

The size and quantities of the bottom shelves can be different according to
model number.

INST ALLATION OF THE BOTTOM SHELVES

1) Before adding cans or bottles to cooler, please install bottom shelves.

2) Then install dividers. (see page 4)

4

Turbo air

INSTALLATION OF THE DIVIDERS

1) To re-position divider, push back wards.

2) Spring in back of divider point ‘C’ will be shorten to about 1/2 inch.

3) Front of divider will be able to remove from point ‘A’ and ‘B’.

4) Position divider in the hole, point ‘C’ where you would like it.

5) Push divider back wards.

6) Insert front of divider in the holes, point ‘A’ and ‘B’, where you would like it.

* Note :

The shape and quantities of the dividers can be different according to model
number.

‘A’

‘B’

‘C’