Turbo Air RHW-450 Installation Manual

OWNER & OPERATOR
INSTRUCTION MANUAL

Model No. RHW-450

HAND WRAPPER

www.turboairinc.com

For service contact:

German Knife Inc.

1-800-500-3519

www.turboairinc.com

TABLE OF CONTENTS

PAGE

INSTALLATION

MAINTENANCE

SPECIFICATIONS

WARRANTY INFORMATION

3-4

5-6

7

8

German Knife, Inc.

4184 E. Conant St., Long Beach, CA 90808

Phone: [phone]

Fax: [phone]

www.turboairinc.com

SHIPPING DAMAGE CLAIM PROCEDURE

The equipment is inspected & crated carefully by skilled personnel before leaving factory. The transportation company
assumes full responsibility for safe delivery upon acceptance of this equipment if shipment arrives damaged;

1. VISIBLE LOSS OR DAMAGE: Note on freight bill or express delivery and signed by person making delivery.

2. FILE CLAIM FOR DAMAGES IMMEDIATELY: regardless of extent of damages.

3. CONCEALED LOSS OR DAMAGES: If damages are noticed after unpacking, notify Transportation Company
immediately and file “Concealed Damage” claim with them. This should be done within fifteen (15) days from date
delivery is made to you. Return container for inspection.

2

INSTALLATION

A

UNPACKING:

1. Remove appliance from container.

2. Remove all protective packaging material.

3. Retain container and packaging material until the appliance is operated and found
in good condition.

4. Check appliance for any shipping damage. If appliance shows any external or internal
damages, promptly inform dealer/distributor where you bought your appliance.

NOTE: Installation and repair should be done by a qualified service person. Qualified service person;

who have read these instructions and is familiar with the operation and functions of the equipment.

GENERAL SAFETY INSTRUCTIONS:

ccidents are always tragic especially because so many of them could have been prevented with
little care and judgment. There are some basic good practices; we hope you will follow for safe
use of the equipment.

INSTALLATION:

1. Always clean equipment interior and exterior thoroughly before using.

2. Keep away from water or moisture.

3. Check rating label for your model designation & electrical rating.

4. Set film on back roller and install the film as shown below.

5. Set earth wire for preventing electric shock.

6. Adjust the tension bolt in order to have elasticity in pulling of the film.

3