Tumbl Trak 5in1 Assembly Instructions Manual
5-in-1 Assembly Instructions
Thank you for purchasing the
5-in-1 Bar. You will enjoy years of
use with this product.
Parts ListParts List
J
Aer opening the boxes, please
check the parts list to make sure all
pieces have arrived in good
condion.
If you have any quesons during
this assembly process, please call
customer service at
1-800-331-4362.
A
B
Parts List:
[A] Side Legs (qty 2)
[B] Kip Bar assembly (qty 2)
[C] Vercal Supports (qty 4)
[D] Center-Beam Support (qty 2)
[E] Buon-Head Cap Screws (qty 8)
[F] Lock Washers (qty 8)
[G] Flat Washers (qty 8)
[H] 6mm Allen Wrench (qty 1)
[I] D-2 Spring-Detent Knobs (qty 4)
A
C
D
For quesons or problems, please call Tumbl Trak at
(800) 331-4362
B
G
E
F
H
I
C
D
Step 1
Step 1- Place the screw through the lock
washer and then the at washer. Repeat for
Step 2- Align the one of the uprights with the center
support. Align the second upright with the center
support. NOTE: Make sure D-2 knob holes are facing
Step 3
Step 3- Place two of the screw and washer sets
into the upright and center support on each
end. Tighten these by hand. NOTE: It will be
Step 2
Step 4- Repeat Steps 2 & 3 for
the second set of uprights and
center support.
Step 6
Step 5- Place the downtubes of the bar assembly into
the uprights. You may have to adjust the
uprights to allow the downtubes to slide in. If it is sll
dicult spray some WD-40 on the downtubes. Repeat
Step 6- Once the bar assembly is seated all the
way in the upright, nish ghtening the
screws in the center support. Repeat for sec-
Step 7- Place the D-2 knobs
in all four uprights.
Step 8- Adjust the bars to your desired height
and ghten the D-2 knobs. Ensure you see
and hear the knob lock. NOTE: You should
not be able to move the bar assembly if it is
properly locked with the D-2 knobs.
Step 5
Step 6
Step 6
NOTE: Tumbl Trak equipment is not recommended for
the use in Parkour/Free Running related activities.
For quesons or problems, please call Tumbl Trak at
(800) 331-4362
Loading...