Tuffy Security 103 User Manual

INSTALLATION INSTRUCTIONS

Single Compartment Overhead Console #103

Please read and fill out the enclosed warranty registration card to activate your warranty.

Shipment Contents

103 Loop Bracket Footman Loop Bracket Electronics Support Frame Adjustable Support Bracket

(For wranglers 03+) (For wranglers 01-02)

Lower Adjustment Piece Upper Adjustment Piece Main Console Body

Shipping Package

(4)6-32 Flathead Phillips (2)6-32 Unslotted Screws (2)10-32 Panhead Phillips

(2)10-32 Flat Phillips (3)10-32 Button head Screws (2)1/4-20x3/8 SocketHead Screws

(3)3/16” Washers (2)1/4” Washers (4)5/16” Washers (2)5/16” Barrel Nuts

Page 1 of 5 - 6/4/2008 – Rev122006

Shipping Package (Continued)

(2)10-32 Lock Nuts (4) 5/16” Lock Nuts (2) 1” Diaphragm Grommets

(2) 5/16” U-Bolts (2)5/16-18x3” Carriage Bolts Rubber Seal

TOOLS NEEDED

• 1/8” Allen Wrench

• 3/16” Allen Wrench (Wranglers Pre 2003 without full roll cage only)

• T-20 Torx Driver (Wranglers Pre 2001 only)

• Small Phillips Screw Driver

• 5mm Allen Wrench

• ¼” Socket

• ½” Socket and Ratchet – Extensions and Swivels are helpful (Vehicles with Roll Cage only)

PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLA TION.

These instructions will guide you through the installation of your new overhead console in the fo llowing
vehicles:

• Stock Jeep Wranglers 2000 or earlier

• Stock Jeep Wranglers 2001-2002 (With Footman loop riveted to windshield)

• Stock Jeep Wranglers and Rubicons 2003+ (With Large Oval Roll bar Pad)

• Vehicles with a full roll cage and distance from front to rear bar between 28” to 36-1/2”

If your vehicle does not fall into one of these categories you may have to make modifications to mounting
brackets, and/or purchase additional hardware.

Page 2 of 5 - 6/4/2008 – Rev122006