Tuffy Security 048 User Manual

INSTALLATION INSTRUCTIONS

Overhead Console Part #048

Please read and fill out the enclosed warranty registration card to activate your warranty.

Tools Needed



Ratchet ( ¼” Drive)



3/16” Allen wrench



T-20 torx wrench



7/16” socket



½” socket



¼” drive ratchet extensions (12-16” of extension depending on vehicle)



1/8” Flat slotted screwdriver



3/8” wrench or ratchet

Shipping Package

(3) U-bolts

(2) ¼-20x3/8 Socket head cap screws

(8) ½” hole plugs (6) 1” rubber grommets (6) 5/16 SAE Washers

(8) ¼-20x1/2 Socket head cap screws

(2) ¼” Washers

(8) 7” Zip ties

(6)5/16” Locknuts (5)10-32 Locknuts (2)10-32x3/8 Slotted screws (2)10-32 washers

Page 1 of 5 - 1/23/2012 – Rev122006

Parts Reference List (included parts)

Rear Sliding Assembly Drawer (2 each)

Main Body Assembly Links (8 each) Loop Bracket

(Factory installed)

Mounting Directions

Refer to the pictures on the next page to help illustrate instructions.

1. Decide where you want to run your stereo and/or CB wires; either to the front of the console by
running wires on the edge of the windshield, or to the rear of the console by running wires along
the rollbar.

2. Extend the wires to the mounting location (A CB antenna extension wire can be purchased at any
Radio Shack or similar electrical shop). Cut out the center of the rubber grommets you will be
feeding wires through and install all (4) grommets in the four one inch holes on the front and rear
of the console.

3. Remove the footman loop from the top center of the windshield of your Jeep using a T-20 torx
wrench (If the footman loop on your Jeep is riveted on and cannot be removed or it has a full cage
ignore this step).

Page 2 of 5 - 1/23/2012 – Rev122006