Tuffy Security 035 User Manual

INSTALLATION INSTRUCTIONS

CJ Security Glove Box Part #035

Please read and fill out the enclosed warranty registration card to activate your warranty.

Shipping Package

(6) 10-32 x 1/2” bolts (6) 10-32 locknuts

Tools Needed

o (1) 5/16” wrench
o (1) 3/8” wrench

Installation

1. Please read all instructions before starting installation.

2. Remove the old cardboard glovebox, latch, and lid.

3. Insert the Tuffy glovebox line up the mounting holds with the holes in the dash.

4. Insert the (6) 10-32 x 1/2” bolts from inside the glovebox. Reach behind the dash and
fasten the (6) 10-32 locknuts starting with the bolts on the sides of the glovebox. See the
figure below (Shown without the lid).

5. Lock it up!

Page 1 of 2 - 1/28/2008 – Rev122006

ATTENTION:

FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM

The pushbutton lock contains an “O” ring seal to protect the interior from dust and water. If this
mechanism is not lubricated regularly it will become difficult to operate and it may not return to its
home position preventing the key from operating the lock. If this happens simply pull up on the
pushbutton to manually bring it back to its home position. Lubricate the pushbutton with a light
lubricant such as silicone spray. The pushbutton may have to be periodically disassembled and
cleaned.

Call [phone] for Technical Support

Page 2 of 2 - 1/28/2008 – Rev122006