Tuffy Security 031 User Manual
PARTS CHECKLIST
(8) 5/16” x 1-1/4” Bolts
INSTALLATION INSTRUCTIONS
SECURITY LOCKBOX SET #020 AND #031
Please read and fill out the enclosed warranty registration card to
activate your warranty.
(8) 5/16” Nylock Nuts (16) 5/16” Washers Rubber Seal Package
(6) #4 Nuts (6) #4 Washers (4) 5/16” Hole Plugs
TOOLS NEEDED
• Electric drill
• 3/8” Drill bit
• Marker or pencil
• Knife
• ½” Socket and ratchet
• ½” Wrench
• ¼” Wrench or Socket and Ratchet
• Silicone sealant (Recommended)
PLEASE READ ALL INSTRUCTIONS THOROUGHLY BEFORE STARTING INSTALLA TION.
This section applies to Part # 020 only
1. Bolt your speaker to the Tuffy box by placing the speaker cloth between the speaker and the box and
securing with fasteners provided with the speaker.
2. Route speaker wires through either the hole in the bottom of the box or the hole on the side of the box .
3. If you did not route the wires through the hole in the side of the box, plug the hole with the 5/16” plug
provided.
4. Connect speaker wires to speaker in accordance to the speaker installation manual.
Page 1 of 2 - 1/28/2008 – Rev011607
5. Install rubber seal on lid and check lock operation.
6. Place your Tuffy box in the vehicle on the wheel well, make sure placement of box does not interfere
with the movement of the seat or convertible top.
7. Using a marker or pencil, mark any (3) spots through the 3/8” mounting holes in the box.
WARNING!
Make sure that there is nothing under the vehicle that will be damaged by the drill bit when drilling.
8. Remove the box. Cut the carpet at the (4) marked holes. Using a 3/8” drill bit, drill out the (4) marked
spots in the floor.
9. It is recommended to use silicone sealant in any holes drilled in the vehicle to prevent rusting.
10. Bolt the Tuffy box to the vehicle using (4)5/16x1-1/4” Bolts, (4) 5/16” Nuts and (8) 5/16” Washers.
For security purposes it is best to insert the bolts from the underside of the vehicle up.
11. Part # 020 only - Slide the divider down and then over the screws inserted in your Tuffy box. Secure
the divider to the box using the (3) #4 washers and (3) #4 nuts provided. (See FIGURE 1)
12. Repeat steps for installation of box on the other side of the vehicle.
Call (970) 564-1762 for Technical Support
Page 2 of 2 - 1/28/2008 – Rev011607
Loading...