Tuffy Security 027 User Manual
INSTALLATION INSTRUCTIONS
Universal Security Lockbox Part #027
Please read and fill out the enclosed warranty registration card to activate your warranty.
Shipping Package
(1) Mounting Bracket (4) 5/16” x 1 ¼” Bolts (4) 5/16” Washers (4) 5/16” Nuts
Tools Needed
o Power drill
o 3/8” drill bit
o (2) ½” wrenches
Installation
Read all instructions before starting installation
If the lockbox will be mounted under the hood on the wheel well, attach the mounting
bracket to the lockbox first (See FIGURE 2).
1. Place the lockbox in the vehicle
If the lockbox will be mounted in a 87-95 Wrangler no drilling is required.
2. With the lockbox in place mark the mounting holes.
Warning!
Make sure there is nothing under the vehicle that will be damaged while drilling
3. Remove the lockbox and drill out the marked spots.
4. Fasten the lock box to the vehicle using the 5/16” hardware provided. (See FIGURE 1)
5. Lock it up!
Page 1 of 2 - 1/28/2008 – Rev122006
ATTENTION:
FREQUENT LUBRICATION IS NECESSARY ON THE LOCKING SYSTEM
The pushbutton lock contains an “O” ring seal to protect the interior from dust and water. If this
mechanism is not lubricated regularly it will become difficult to operate and it may not return to its
home position preventing the key from operating the lock. If this happens simply pull up on the
pushbutton to manually bring it back to its home position. Lubricate the pushbutton with a light
lubricant such as silicone spray. The pushbutton may have to be periodically disassembled and
cleaned.
Call (970)564-1762 for Technical Support
Page 2 of 2 - 1/28/2008 – Rev122006
Loading...