Wood Nesting Hutch
Assembly Instructions
Complete your Wood Hutch by attaching to the Universal Welded Wired Pen!!
Shown with optional Universal
Welded Wire Pen.
Important Notes:
Lay out all components prior ro start of assembly.
Flat level surface recommended for assembly.
If any components are missing or damaged do not return to retailer.
Please visit our website to see our complete line of products.
2” x 10’ “ Block (2) - These are used in conjuction with the Universal Welded Wire Pen. If
you attach the Wood Hutch to the Welded Wire Pen, these blocks should be screwed on
to the back edge to level the hutch and keep it o of the ground.
Step 1
Step 2
Step 3
Stand Front Panel (A) upright and attach
both Side Panels (H) using pre-drilled
holes in Front Panel (A). Two (2) screws
(J) wil be used for each side. Ensure that
the ledge on Side Panels (H) are facing
the inside of the box.
Step 4
Insert both Nesting Box Floor Panels (E)
on either side of Center Divide Panel (G).
No screws are necessary.
Place Floor Panel (C) inside previously
constructed panels. Next, attach Back
Panel (B) to both Side Panels (H) using
(4) screws (J). Two per side.
Step 5
Place one Nesting Box Lip (F) one
Center Divide Panel (G) on the Floor
Panel (C) and attach using (2) screws (I).
Repeat this step for the upper Nesting
Box Lip Panel (F).
Insert Center Divider Panel (G) and
attach to Back Panel (B) using (1)
screw (J) at pre-drilled hole on
Back Panel (B).
Step 6
Place Roof Panel (D) on top of Wood Hutch.
The roof is meant to have overhang on the
front and back. You can place it where it suits
you and screw in place using (4) screws (J).
Also, take the time to place (4) screws (J) into
the pre-drilled holes at the bottom of the
Front and Back Panels to secure them to the
Bottom Panel. You will use (2) screws per side.
Loading...