Tucker-Davis Technologies, Inc. RZ5, RZ5D, RZ5P, RZ6 Operator's Manual

RZ5/RZ5D/RZ5P/RZ6 Processor

Operator’s Manual

RZ5/RZ5D/RZ5P/RZ6 Processor Operator’s Manual
Copyright

© 2010-2019 Tucker-Davis Technologies, Inc. (TDT). All rights reserved.
No part of this manual may be reproduced or transmitted in any form or by any means,

electronic or mechanical, including photocopying and recording, for any purpose without
the express written permission of TDT.

Tucker-Davis Technologies
11930 Research Circle
Alachua, FL 32615
USA

Phone: [phone]
Fax: [phone]

Notices

The information contained in this document is provided “as is,” and is subject to being

changed, without notice. TDT shall not be liable for errors or damages in connection with
the furnishing, use, or performance of this document or of any information contained
herein.

The latest versions of TDT documents are always online at www.tdt.com/support.htm.

A CAUTION informs users when failure to take or avoid a specified action could result
in damage to the product or loss of data.

A WARNING calls attention to an operating procedure or practice that, if not correctly
performed or adhered to, could result in personal injury or death. Do not proceed beyond
a WARNING notice until the indicated conditions are fully understood and met.

Updated: 1/17/2019 11:37 AM

1

Operator’s Manual

RZ5/RZ5D/RZ5P/RZ6 Processor

The RZ5/RZ5D/RZ5P/RZ6 device chassis house an integrated zBUS communication interface,
power source, and monitor speaker.

Functional Diagram

Power Supply

The power supply is integrated into the device and is shipped from the factory with the desired
voltage setting (115 V or 230V) preset. If you need to change the voltage settings for different
regional use please contact TDT support at 1-386-462-9622 or email [e-mail].

Using the RZ5/RZ5D/RZ5P/RZ6 Processor Device

This manual provides the directions necessary for powering the Processor on and off as well as its
communications functionality and User Interface features. Refer to the System 3 Manual provided
by TDT for specific instructions on how to program the RZ5, RZ5D, RZ5P, or RZ6 Processor
device.

Applying Power to the RZ5/RZ5D/RZ5P/RZ6

CAUTION! Allow at least 2 cm clearance from each side of the chassis for proper

cooling. A single ventilation fan is provided on the side of the chassis.
Operating the RZ5/RZ5D/RZ5P/RZ6 chassis with the ventilation obstructed
may cause a malfunction or fire.