Page 1
WARRANTY AND OWNER REGISTRATION
Your Shred Pedal is warranted for a period of
THREE FULL YEARS against defects to the original,
registered owner provided he/she has returned a
completely filled-out OWNER’S REGISTRATION CARD.
This warranty covers parts and labor only; shipping
charges remain the sole responsibility of the owner.
Damage due to modification or abuse is excluded from this
warranty. Before returning any unit for service, a
RETURNED MERCNANDISE AUTHORIZATION NUMBER
(RMA) must be obtained.
Manufacturer is not responsible for consequential or
inconsequential damages resulting from any application or
use of this product. Manufacturer and sales agents assume
no liability or responsibility for safety or injury relating to the
use of the Smooth pick pedal, and user agrees to hold
manufacturer and designer harmless in this regard. This is
the full extent of the warranty; no other warranties implied
or intended.
For service and return authorization contact:
7811 E. Pierce St. § Scottsdale, AZ 85257
Ph: 480-941-0705 Fax: 480-946-2412
www.genzbenz.com
MODEL 310
Shred Mega Tube
You’ve just purchased the vintage tube overdrive
pedal that started it all—Shred mega Tube! Please take a
moment to look over this brochure, and be sure to send in
the owner’s registration and your comments.
Again from the leading innovator of modern tube
overdrive, B.K. Butler, a major break-through in the classic
12AX7A tube sound. The ability of the Shred to be
powered from a common 9-volt battery eliminator puts this
petal into your hands for under $100.
Your new Shred pick pedal operates from the same
type of battery eliminator as most of your battery-operated
effects (9-volt DC 300mA Min.).
The best thing about your Shred pick pedal is that
instead of bogus, cheap, solid state overdrive, you now
have the fat, warm, searing real tube sound.
Page 2
Shred Mega Tube
SPECIFICATIONS
(For those who don’t trust their ears)
OPERATION
Plug in a battery eliminator (9-volt DC 200mA Min.)
and allow the tube to “warm up” for about 15 seconds.
Then plug your guitar into the “in” jack, and your amp to the
“out”. Set the Death, Dr. E.Q. and Riptide controls to where
your ears feel good, and you’re set. (The red LED shows
the Shred Pedal is active).
THE SHRED
The heart of your Shred is the favored pre-amp tube
in the music industry, the 12AX7Z twin triode. The life is 24 years under normal use. We do not recommend any
brand tube for replacement other than a genuine “Real
Tube”, as they are specifically matched and tested.
VOLTAGE REQUIREMENT : 9V DC, 200mA Min.
TUBE TYPE :12AX7/ECC83-Real Tube
INPUT IMPEDANCE :1 MEG. OHMS
SIN RATIO :65 dB (Typical)
HUM & NOISE :-75 dBV (Typical)
OUTPUT HAPEDANCE :10K OHMS (Typical)
OUTPUT LEVEL :0 dBV, .78 VRMS (Typical)
WEIGHT :3 lbs. shipping
DRIVE SENSITIVITY :-65dBV (0.4 mV)
Loading...