Tube Amp Manufactur Organ Drive Operating Manual
Organ Drive
2X ECC83/12AX7
5
4
3
2
1
0
VOLUME 1 VOLUME 2
4
3
2
1
0
5
GAIN
6
HIGH
7
8
9
10
6
CRUNCH
7
8
9
10
3
2
1
3
2
1
4
0
4
0
5
5
DRIVE
3
2
1
0
-
TREBLE
5
4
0
FACTOR
+
6
7
8
9
10
6
7
8
9
10
6
DIRTY
7
8
9
10
CHANNEL BYPASS
AC 12V 1AOUTPUTINPUT
PRESENCE
BYPASS
EXTREME
OFF
HARD
TUBE DISTORTION
MADE IN GERMANYTUBE AMP MANUFACTUR BERLIN
___________________________________________________________________________________________________________________
Operating manual
Safety note
Please note that the tubes for the
the prescribed tubes and the corresponding cover. Do not open the
specialist workshop if necessary.
Make sure that no moisture can penetrate into the housing.
Connector
Connect the cable of the supplied AC adapter to the AC 12V 1A socket. The plug has a bayonet
connection. This is locked by a slight clockwise rotation of the ring and prevents the plug from slipping
out by mistake during operation. Connect the power supply itself to an electrical outlet (230V).
The instrument (organ/keyboard) is connected to the input socket,
the output is connected to your amplifier system (Leslie/amplifier/mixer or similar) to
control elements:
CHANNEL
BYPASS
HIGH
VOLUME 1
GAIN
CRUNCH
VOLUME 2
DRIVE
DIRTY
TREBLE
PRESENCE
EXTREME
HARD
FACTOR
OFF
Organ Drive
to switch between channel 1 and channel 2
Channel 1 is indicated by a yellow LED, channel 2 by a green LED
to turn the effect on and off
The BYPASS function is indicated by a red LED labelled BYPASS.
for rough adjustment of the input level
Normal position: HIGH (only if the input stage is permanently overloaded, switch off
HIGH)
to control the volume of channel 1
for exact adjustment of the input level and for overloading channel 1 (also active for
channel 2)
for permanently crunchy sound in channel 1 even at lower input levels and to achieve a
very groovy sound
to control the volume of channel 2
to control the overdrive of channel 2
to achieve a groovy - slightly dirty sound in channel 2
for raising or lowering the treble in channel 2
for further boosting of medium and high frequencies in channel 2 (when PRESENCE the
TREBLE - controller has a greater influence)
to achieve extreme but harmonic distortions in channel 2 (with FACTOR adjustable)
for harder distortion (e.g. tube Leslie 122) in channel 2 (with adjustableFACTOR
to control functions EXTREME/HARD in channel 2 (only with switched on EXTREME
or HARD active)
EXTREME, HARD and FACTOR are switched off
are operated with high voltage. Operate the device only with
Organ Drive
yourself, but leave it to a
)
Loading...