![](/html/d8/d869/d869c7c1218725fac401e679be94e0c538b851c165c04c3c58139253f0f8bdb1/bg1.png)
„blue note“
Complete tube Guitar Amplifier
(TOP + COMBO)
- Operating manual -
www.tubeampmanufactur.de
![](/html/d8/d869/d869c7c1218725fac401e679be94e0c538b851c165c04c3c58139253f0f8bdb1/bg2.png)
Contents
Page
Safety information 1
To connect 2
Initial operation 2
Front Panel Operation
“BOOST” switch
2
The channels
3
“GAIN" +"VOLUME" controllers channel 1
3
GAIN", "TONE/DRIVE" + "VOLUME" controllers channel 2 3
“TONE" + "DEEP" switch
4
"BASS", "MID" + "TREBLE" Controllers
4
“Reverb” controller
4
Rear panel operation
EXT SP 8/16 OHM" connection
5
“SPEAKER” connection
5
“TWEETER” switch
5
“LINE OUT” connection
5
“SEND" + "RETURN" connections
5
“FOOTSWITCH” connection
6
Folding system
6
Technical Data 6
![](/html/d8/d869/d869c7c1218725fac401e679be94e0c538b851c165c04c3c58139253f0f8bdb1/bg3.png)
1
Safety information
For the power supply of the unit, only a correct Schuko connection according to the valid IEC
(ANSI) specifications may be used. Under no circumstances may the earthing contact cable be
interrupted. The pre-set operating voltage must correspond to the local mains voltage. Make
sure that the mains cable is not damaged. It must be replaced if damage is visible. You can do
this yourself, as it is a commercially available Euro mains cable which is connected to the unit via
a plug connection.
If the mains fuse on the unit has to be changed, it must first be disconnected from the mains
(pull out the mains plug). The type and current of the fuse must correspond to the specifications
on the unit.
This amplifier may only be operated in dry rooms. Make sure that no moisture can penetrate
into the unit.
During operation the amplifier must be well ventilated so that the generated waste heat can
escape. It should therefore be free-standing and under no circumstances be covered (fabric,
blanket tarpaulin, foil, etc.).
The device may only be opened for any adjustments, repairs, etc, by authorised specialist
personnel.
The amplifier is able to generate high volumes. High volume levels can cause permanent hearing
damage. Avoid therefore the direct proximity of loudspeakers, which are operated with high
volume levels. Use hearing protection under continuous exposure to high volume levels.
The manufacturer assumes no liability for damage to the device and / or to persons and other
creatures (such as pets) caused by improper operation or failure to observe one or more safety
instructions in this manual.