TTE Technology 75C807 User Manual

Hi! Let’s get started.

C-Series C807/C803

DO NOT RETURN TO STORE

WE ARE READY TO

HELP

with any questions

TAKE CARE WHEN REMOVING THE TV

VISIT US AT WWW.TCLUSA.COM

TCL SUPPORT:

www.tclusa.com/support

1-877-300-8837

Important Information

CAUTION

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

Caution: To reduce the risk of electric shock, do not remove cover (or back). No user serviceable parts inside. Refer servicing to qualiﬁed service personnel.

This symbol indicates “dangerous voltage” inside the product that presents a risk of electric shock or personal injury.

WARNING

To reduce the risk of ﬁre or electric shock, do not expose this product to rain or moisture. This product should not be exposed to dripping or splashing. No objects ﬁlled with liquids, such as vases, should be placed on the apparatus.

This symbol indicates that this product incorporates double insulation between hazardous main voltage and user accessible parts. When servicing, use only identical replacement parts.

This symbol indicates important instructions accompanying the product.

WARNING

The TV is unstable if it is not properly attached to the base or mounted to the wall. Please follow the base or wall mounting instructions provided in the User’s Guide to ensure your safety.

Warning: The batteries shall not be exposed to excessive heat such as sunshine, ﬁre or the like.

Refer to the identiﬁcation/rating label located on the back panel of your product for its proper operating voltage.

Cable TV Installer: This reminder is provided to call your attention to Article 820-40 of the National

Electrical Code (Section 54 of the Canadian Electrical Code, Part 1) which provides guidelines for proper grounding and, in particular, speciﬁes that the cable ground should be connected to the grounding system of the building as close to the point of cable entry as practical.

Important: This television is a table model and is designed to sit on a ﬁrm, ﬂat surface. Don’t place the

TV on soft carpeting or similar surface because the ventilation slots on the bottom of the unit will be blocked, resulting in reduced lifetime from overheating. To assure adequate ventilation for this product, maintain a spacing of 1 inch from the top and side of the TV receiver and 2 inches from the rear of the TV receiver and other surfaces. Also, make sure the stand or base you use is of adequate size and strength to prevent the TV from being

the TV. Refer to the Important Safety Instructions on the next page. The Power button on this TV and your remote control puts the TV into a very low-power standby mode

disconnect the power cord from the outlet. The mains plug/appliance coupler is used to completely turn

allows you to disconnect the power cord when desired.

Product Registration

Please register your TCL TV purchase on-line at www.tclusa.com. It will make it easier to contact you should it ever be necessary. Registration is not required for warranty coverage.

Product Information

Keep your sales receipt to obtain warranty parts and service and for proof of purchase. Attach it here and record the serial and model numbers in case you need them. These numbers are located on the product. Warning: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Keep the apparatus at least 8 inches away from the human body.

Input Signal Compatibility

Antenna/Cable Composite Video HDMI

For the best viewing experience, remove the energy guide label from the TV front panel or TV screen before use.

Model No. Serial No.

Purchase Date Dealer/Address/Phone

480i, 480p, 720p, 1080i (NTSC, ATSC, and QAM formats) 480i 480i, 480p, 720p/60Hz, 1080i/60Hz, 1080p/60Hz, 2160p/24/30/60Hz

Important Safety Instructions

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampliﬁers) that produce heat.

9. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

10. Only use attachments/accessories speciﬁed by the manufacturer.

11. Use only with the cart, stand, tripod, bracket, or table speciﬁed by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

12. Unplug this apparatus during lightning storms or when unused for long periods of time.

13. Refer all servicing to qualiﬁed service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

14. For safe operation of the apparatus, observe these installation requirements: Keep at least 2 inches of ventilation space between the rear cover of the apparatus and the wall. Keep at least 1 inch of ventilation space between the apparatus and all other surfaces. Do not allow any of the apparatus’ ventilation openings to be blocked by objects that might obstruct them, such as; newspapers, curtains, table-cloths or any other objects. Do not expose the apparatus to any external heat sources. Do not place any heat sources such as candles, lamps, etc. on the apparatus. Do not expose the device to high levels of humidity or to any possible sources of moisture. When disposing of used batteries from the remote control, consult local regulations regarding proper disposal.

15. If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-2011 (Section 54 of Canadian Electrical Code, Part 1) provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead in wire to an antenna-discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See following example:

ELECTRIC SERVICE EQUIPMENT

ANTENNA LEAD IN WIRE

GROUND CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PARTH)

What’s in the box

TCL Roku TV AV Input cable adapter

TV stands

TV remote

2 x covers for stand hole

2 x AA batteries

for remote

only for C807 Series

What you need

Power

cable

4 x Phillips screws

M5X26mm for models 49”

M5X30mm for models 55”, 65” & 75”

In-ear headphones

VESA mount spacers

2 PCs for models 65” & 75”

4 PCs for 49” & 55”

TV remote

Make the most of your Smart TV

AV terminal cover

4 x VESA screws

M6X30mm for models 75”

2 x AAA batteries

for remote

only for C803 Series

Phillips head

screwdriver

Router + Internet Connection

(needed for streaming)

For additional support, please see User Manual at: www.TCLUSA.com/support

Key things to know: A paid subscription or other payments may be required for some streaming channels.

Channel availability subject to change and varies by country.

+ 11 hidden pages