
Purpose
The recorders of the Edic-Mini CARD (16) series are professional devices intended for
making high quality record of voice messages onto microSD flash card with the capacity
from 2GB to 32 GB.
Recorders of the Edic-Mini series feature really unique characteristics, among which
the tiniest size, maximum autonomy, and high acoustic sensitivity.The recorders have
proved themselves as personal means of recording audio information. The recorders
are meant for domestic use by a mass consumer.
Audio files are recorded in standard WAV format using FAT32 file system, enabling
the user to playback the recordings on almost any PC, tablet or mobile phone by a
standard media player. To process records and to facilitate the conversion of records to
text, there is the SoundProcessor program operating under WIndows XP (SP2, SP3),
Vista, Windows 7, 8. This program is on the supplied flash card and is also available for
downl oad fr om our we bsi te: www.ts-market.com.
Main technical characteristics of the recorders:

geable
battery
38х18.5х23.5 120 80 15 8;16 0,1-10
geable
battery
55х17х5;
7
30
х10.8;
4
18 72 15 8;16 0,1-10
*take into account that the parameter of autonomy is specified for Record Mode 8KHz/8 bit, in
case of higher sampling rate or capacity, autonomy value is lower (for 16 KHz/16 bit approximately
by two times for the recorders with rechargeable batteries and by four times for the recorders with
batteries). Autonomy value considerably depends on battery capacity, its recency, as well as on
the model of microSD in use.
• Battery life for a f lash car d with the c apacit y of 8 GB:
in the m ode 8 KHz /8 bit - 272 hours,
8 KHz/16 bit and 16 KHz/8 bit - 136 hours,
16 KHz/1 6 bit - 68 ho urs .
For flash cards w ith alternative capacit y values, battery li fe is measured in
direct ratio to battery capacity.
• Allowa ble operation-and-storage temperature: 0…+50° C
• Operating lifetime: 3 years
3

Main Features
• VAS (Voice Activation System).
• 4 timers to enabl e recording at the preset time.
• Linear and circular recording (black-box mode).
• Built-in clock, calendar, attachment of records to time and date.
• Contr ol and indication: Switch and 2 LEDs.
In Box
• Recorder
• USB Reader to operate flash card
• 2 GB flash card
• 1 battery (for the recor ders with batteries)
• USB cable for charging ( for the recorders w ith rechargeable batteri es)
• Operating instruction.
Operating the Recorder
For recorders with batteries, install the battery into the corresponding compartment.
When installing, always observe polarity (see marking on the Recorder’s case).
Inappropriate installing of battery may lead to failure of the Recorder system, which is
not covered by the Warranty. Do not store the Recorder for a long time with a battery
inserted, as the battery may leak and lead to Recorder failure, and that is not covered
by the Warranty.
For recorders with rechargeable battery, first charge the battery. To do this, gently
and without strain follow the correct polarity, insert the flat side of the supplied cable
into the connector of the flash card, and the other side to the USB port of the PC or
a charger, e.g. of a mobile phone, with output voltage 5V and a USB connector. It
should be considered that a charging cable does not have a rigid fixation in the flash
card connector, that’s why both cable and the Recorder should be placed in the way to
4

maintain contact while charging. During charging red LED is on, after charging has been
completed, green LED is on. Full charging takes approximately 3-4 hours. To retrieve
charging cable, press on the cable and retrieve it.
Please note! In order to avoid deep discharge and related damage of the rechargeable
battery, the Recorder must be charged at least once a month. The failure of the
battery due to its deep discharge is a violation of the rules of operation.
MicroSD Card Preparing
MicroSD card which is in the delivery set, doesn’t require any preliminary
preparation. It is formatted in FAT32 and there is also a configuration file
CONFIG.INI containing Recorder’s settings; text file EVENTS.TXT containing
information about using the Recorder; detailed instruction to operate the Recorder,
and SoundProcessor program. Procedure of other microSD card preparation, as well
as Recorder’s settings is descr ibed in Full Oper ation Manual.
Recommended! Transfer information on your flash card to your PC!
Starting the record
To start recording, set the Switch to On position. Green LED flashes, and the Recorder
starts recording. During recording, green LED is flashing by two series of flashes,
indicating:
Battery charge level (1st series)
Free memory capacity (2d series)

Red LED flashing when enabling recording states for one of the following contingency
situations: 3 flashes - battery or rechargeable battery is discharged, 3 series of 3 flashes
indicate flash card failure (full, cannot be read or not available). To stop recording, shift
the Swi tch to Off position. Green LED fl ashes and recording stops.
Record Playback
By pressing on the flash card, remove it from the Recorder. Insert flash card into
the supplied reader, then connect Reader with the card to the USB port of the PC.
Flash card should be recognized as a separate disk with recorded WAV files of audio
recording, which can be played back by any media player.
To avoid failure of audio files, it is prohibited to remove flash card while any of the
LEDs is on.
Reset
In case of a contingency situation with Recorder’s rechargeable battery, use any
pointed object (match, toothpick etc.) to press the Reset button. Green LED flashes
once. For the recorders with batteries - remove the battery and insert it back after a
while.
Detailed information about capabilities of recorders is available in Full
operation manual on recorder’s microSD card, as well as on our website:
www.ts-market.com
Warranty
The manufacturer undertakes warranty repair liabilities for 1 year from the date of
purchase, but no longer than 2 years from the date of manufacture of the product
(warranty does not cover batteries), other rules are regulated by the Law “On Protection
of Cons umers’ Rights”.
Further there is usually a long list of non-warranty cases. We have a different approach.
We make use of every warranty case as an opportunity to find out the causes and
6

make our products better. Therefore, we are always grateful for any comments and
proposals regarding our products, as well as the detailed description of the conditions
and causes that led to failure. We appreciate time and skills of our customers, and if the
problem is not that complicated, we do not mind if you try to solve the problem yourself.
If the attempt to repair was fairly neat, you do not lose your warranty. In case of major
break downs and mechanical damage to the
Recorder, your warranty will be terminated. Our products have no seals. If you are
experiencing problems with the use of our products, we recommend the following:
1. Go to www.ts-market.com and see a list of common problems and their
solutions. Perhaps there is a solution to your problem.
2. If t he problem persists, contact technical suppor t at support@ts -market.
com with the detailed description of your probl em, the conditions it
appear ed, the exact product name according to the passport , firmw are,
software, operating system, an d other relevant i nformati on. Remember,
the better you describe the problem, the sooner it is resolved. The calls like
“It doesn’t work at all!” are least effective. E-mail correspondence is most
effective because it preserves history and minimizes misunderstanding.
You will receive a response to your request by e-mail withi n 24 hours
(exc luding weekends an d holiday s).
Technical Support
Technical support is avail able by e-mail: support@ts-market.com
We are constantly working to improve the software and documentation. You can always
download the latest version of the software for free and get information on products on
our website: http://www.ts-market.com.
7