TSM Colibri-SD Quick Start Manual

Quick Start Guide

Control and indication of the Recorder's modes are carried out using two hole-

buttons and three-color LED (between buttons)

on the front side of the device. For

pressing hole-buttons it is recommended to use fine wooden or plastic stick.
Colibri-SD may be used both as voice recorder to record audio files and as flash
card to store any other information.

Voice Recorder. Front view.

Opened Recorder. USB-charger.

1. RECORD button.

2. LED of Status Control.

3. STATUS Button.

4. Microphones

5.

To open flash card chip push
down on the right edge of the
outlined rectangular area.

1. Slot for micro SD-

card and

adaptor for charging.

2. Micro SD – USB adapter for

c

onnecting to PC for charging.

3. Flash card chip

Charging and setting parameters

1. Charge the recorder’s battery using adaptor by connecting it to USB-port of any
PC. For that, if necessary remove SD-card and insert in this slot Micro SD – US

B

a

dapter. Then connect Recorder with adapter to USB of the computer.

2.

To initialize micro SD card insert it to the holder. Then, insert the holder with
micro SD to the PC, run the built-in program “Kolibri_5.exe”, perform the
needed settings and click “WRITE CONFIGURATION”. In order to keep time on
the recorder the same as on the PC, quickly insert SD card to the recorder
and press left hole-button (RECORD button).

3. T

he LED flashes red, then blue then turns off.

4. The recorder is initialized and ready to operate.

1

2

3

4

1

2

3

4

5

5. The recording can be saved onto supplied micro SD or to any other. But you
s

hould remember the password (in case of its setting). If the password is not
set, the recorded information can be played back using any other micro SD
player. If the password is set, before playback it is necessary to descramble the
files saved with password using program.

T

he list of modes and their corresponding LED colors are specified in the Table

below:

LED

color

Mode

Switched

off

Battery is discharged.

Red

Voice Recorder is in Record Mode. Information from the Mic
is recorded onto memory

Green

Standby Mode. Recorder is ready to start operating or
charging.

Blue

Micro SD card is not inserted. Recording is impossible.

Record Mode Activating

For activation of Record Mode, press the Record button (left one). The LED

flashes, its color changing in the following order: Red → green → off.

To stop recording, press the Record button, the LED flashes, its color changing

in the following order: red → off → red → off.

Precautionary Measures

Please note!

• Due to shape of a thin rectangular plate the Recorder must be handled

carefully! Do not place the device into the pants pocket; it could be

damaged when sitting down. Do not bend or hit the Recorder!

• It is also recommended to store the device in a protective case.