TSC TS9013 Technical data

TS9013

500mA CMOS Low Dropout Voltage Regulator

Pin assignment

SOT-89

1. Gnd

2. Input

3. Output

SOT-223

1. Input

2. Gnd

3. Output

Low Power Consumption 2uA(typ)

Low Drop Out Voltage 0.6V

General Description

The TS9013 series is a positive voltage regulator developed utilizing CMOS technology featured very low power
consumption, low dropout voltage and high output voltage accuracy. Built in low on-resistor provides low dropout voltage
and large output current. A 1uF or greater can be used as an output capacitor.
The TS9013 series are prevented device failure under the worst operation condition with both thermal shutdown and
current fold-back. These series are recommended for configuring portable devices and large current application,
respectively.
This series are offered in 3-pin SOT-89 and SOT-223 package.

Features

 Dropout voltage typically 0.4V @Io=500mA (Vo=5V)

 Output current up to 500mA

 Low power consumption, 2uA(typ) @Vo=5V

 Output voltage +/-2%

 Internal current limit

 Thermal shutdown protection

Applications

Ordering Information

Part No.

TS9013xCW SOT-223

TS9013xCY

Note: Where x denotes voltage option, available are

A=1.5V, D=1.8V, K=2.5V, S=3.3V, 5=5.0V.

Contact factory for additional voltage options.

Operating Temp.

(Ambient)

-20 ~ +85 oC

Package

SOT-89

 Palmtops

 Video recorders

 Battery powered equipment

 PC peripherals

 CD-ROM, DVD ROM

 Digital signal camera

Block Diagram

Typical Application Circuit

TS9013 series 1-3 2004/09 rev. E

Absolute Maximum Rating

Input Supply Voltage Vin(max.) +12

V

Input Operating Voltage Vin(opr. Typ.) +10

Output Current Io PD / (Vin – Vo) V

SOT-89 0. 55

Power Dissipation (without heat sink)

SOT-223

SOT-89 180

Thermal Resistance

SOT-223

SOT-89 18

Thermal Resistance

SOT-223

Operating Junction Temperature Range Tj -40 ~ +125

Storage Temperature Range T

PD

RӨja

RӨjc

-65 ~ +150

STG

0.625

160

15

W

o

C/W

o

C/W

o

o

C

C

Lead Soldering Temperature (260 oC) 10 S

Caution: Stress above the listed absolute rating may cause permanent damage to the device.

Electrical Characteristics

Ta = 25

Output Voltage

Maximum Output Current Vin=Vo+1V, 500 -- -- mA

Input Stability Vo+1V ≤ Vin ≤ Vo+2V, Io=1mA -- 0.2 0.3 %

Load Regulation (Note1)

Dropout Voltage (Note 2)

Quiescent Current Vin=Vo+1V, Io=0A -- 2 5 uA

Output Current Limit Vout < 0.4V -- 550 -- mA

Power Supply Rejection Ratio At f=100KHz, Io=10mA, -- 30 -- dB

Output Voltage Temperature

Coefficient (Note 3)

Note: 1. Regulation is measured at constant junction temperature, using pulsed ON time.

2. Dropout is measured at constant junction temperature, using pulsed ON time, and the criterion is Vout inside

3. Guaranteed by design.

o

C unless otherwise specified.

Parameter Conditions Min Typ Max Unit

TS90135 4.900 5.0 5.100

TS9013S 3.234 3.3 3.366

TS9013K 2.450 2.5 2.550

TS9013D 1.764 1.8 1.836

TS9013A 1.47 1.5 1.575

TS90135 Vin=Vo+1V,

TS9013S

-- 40 80

TS9013K

TS9013D

-- 40 90

TS9013A

TS90135 -- 600 750

TS9013S -- 600 750

TS9013K -- 600 850

TS9013D -- 600 850

TS9013A -- 850 1100

-- 100 -- ppm/

V

mV

mV

o

C

target value +/-2%.

Vin=Vo + 1V, Io

=10mA,

1mA≤I

≤500mA

L

Vin=Vo+1V,

1mA≤I

≤400mA

L

Io=500mA

Io=400mA

TS9013 series 2-3 2004/09 rev. E