T & S Brass & Bronze Works B-0805 Installation Manual

Page 1
Installation and
Maintenance
Limited One Year Warranty
T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/ or replace it. To obtain warranty service, products must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other transpor­tation charges of the product to T&S and the return of repaired or replaced product to the purchaser are the responsibility of the purchaser. Repair and/or replacement shall be made within a reasonable time after receipt by T&S of the returned product. This warranty does not cover Items which have received secondary finishing or have been altered or modi­fied after purchase, or for defects caused by physi­cal abuse to or misuse of the product, or shipment of the products.
Any express warranty not provided herein, and any remedy for Breach of Contract which might arise, is hereby excluded and disclaimed. Any implied warranties of merchantability or fitness for a particu­lar purpose are limited to one year in duration. Under no circumstances shall T&S be liable for loss of use or any special consequential costs, expenses or damages.
Some states do not allow limitations on how long and implied warranty lasts or the exclusion or limi­tation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. Specific rights under this warranty and other rights vary from state to state.
Instructions
B-0805 Series
Metering Faucets
Deutsch: Installations- und
Wartungsanleitungen
P/N: 098-003151-45 Rev.4
Date: 03-08-04
Drawn: TEH
Checked: MVW 03-11-04
Approved: MVW 03-11-04
Español: la Instalación y las
Français: les Instructions
d’Installation et d’Entretien
Page 2
Exploded View
* Some items are listed for instructional purposes
and may not be sold as separate parts.
Page 3
Part Number Guide
Metering Faucet Assemblies
1 Asm, Metering Valve
Blank Valve 238AB Hot Valve 238AH
Cold Valve 238AC 2 Body, Faucet * 3 Aerator, 3/8-18 Male 4 Asm, Rose Spray - 1.40 GPM B-0103-F15 5 Asm, Spray Head 6 Washer GN Tip 052X 7 Holder, Flow Control 8 Flow Control 9 Washer, Shank 000999-45
10 Locknut 002954-45 11 Nut, Nipple Cplg. 12 Asm, Spreader Unit
(B-0805, B-0807)
(B-0806, B-0808)
(B-0806)
(B-0806)
(B-0805, B-0806)
(B-0807, B-0808)
B-0199-02
002209-40
009069-45 001644-45
000958-20 002899-40
Page 4
General Instructions
Installation: (B-0805)
1. Turn off water supply and drain lines. Flush lines thoroughly of debris.
2. Drill a 7/8" diameter hole through sink or countertop in desired location.
3. Remove no.10, no.9 and no.8 from no.7. Place no.7 through opening in sink.
4. Replace no.8, no.9 and no.10 onto no.7 and tighten against bottom of sink. Hold no.2 flat against sink while tightening no.9.
5. Connect water supply to no.10 and check for leaks.
Note: Flow is adjustable from instanta­neous shut-off to extended flow by
external adjustment:
Note: Each metering cartridge is preset for approximately 10 seconds at the factory with 40psi inlet water pressure. They may be reset at installation. If water pressure varies, the cycle time will also vary.
Note: See separate installation instruc­tions 098-009763-45 for models with spreader unit. (B-0806 and B-0808)
sink
8 9 7
10
2
Note: See installation instruction 098-014733-45 for cartridge adjustment.
Page 5
RELATED T&S BRASS PRODUCT LINE
T&S BRASS AND BRONZE WORKS, INC.
A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe
Travelers Rest, SC 29690 ‘De Veenhoeve’ Phone: (864) 834-4102 Oude Nieuwveenseweg 84 Fax: (864) 834-3518 2441 CW Nieuwveen
E-mail: tsbrass@tsbrass.com The Netherlands
Loading...