T&S Brass B-0133 Installation Manual

Step 2:

Apply plumber’s tape to top of riser threads and

attach to spring assembly. Tighten with wrench.

Before starting the installation, be sure to ﬂ ush supply lines and shut off water supply.

Cierre la fuente principal de agua y desagüe las tuberias.

Avant de commencer l’installation, coupez l’alimentation d’eau et purgez la tuyauterie.

Wasser abstellen und Wasserleitungen entleeren.

Step 1:

Apply plumber’s putty to backside of body and

insert into mounting hole. Line up water supply

lines and couplings, attach and tighten with

wrench.

Step 4:

Step 3:

Grab riser assembly and lower the EasyInstall®

end-ﬁ tting into faucet body. Press down until the

end-ﬁ tting “pops” in.

Make sure that the EasyInstall® locking washer is

seated properly inside the faucet body.

Step 5:

Lock the EasyInstall® locking nut in place and

tighten with wrench.

B-0133 Series

PRE-RINSE UNIT

Unit w/Wall Bracket)

(B-0133-B, Pre-Rinse

Installation and

Instructions

Maintenance

Limited One Year Warranty

T&S warrants to the original purchaser (other than for purposes of resale)

that such product is free from defects in material and workmanship for a pe-

riod of one (1) year from the date of purchase. During this one-year warranty

period, if the product is found to be defective, T&S shall, at its option, repair

T&S Brass and Bronze Works, Inc.

Attn: Warranty Repair Department

2 Saddleback Cove

Travelers Rest, SC 29690

and/or replace it. To obtain warranty service, products must be returned to.....

Shipping, freight, insurance, and other transportation charges of the product

to T&S and the return of repaired or replaced product to the purchaser are

the responsibility of the purchaser. Repair and/or replacement shall be made

within a reasonable time after receipt by T&S of the returned product. This

warranty does not cover items which have received secondary finishing or

have been altered or modified after purchase, or for defects caused by physi-

cal abuse to or misuse of the product, or shipment of the products.

Any express warranty not provided herein, and any remedy for Breach of

Contract which might arise, is hereby excluded and disclaimed. Any implied

warranties of merchantability or fitness for a particular purpose are limited to

one year in duration. Under no circumstance shall T&S be liable for loss of use

or any special consequential cost, expenses or damages.

Some states do not allow limitations on how long an implied warranty lasts

or the exclusion or limitation of incidental or consequential damages, so the

above limitations or exclusions may not apply to you. Specific rights under this

warranty and other rights vary from state to state.

098-014497-45 REV. 5

10-27-10

P/N:

DATE:

TEH

JRM 11-03-10

JHB 11-09-10

DRAWN:

CHECKED:

APPROVED:

Fasten wall ﬂ ange to wall using wall mount screws1.

Place 2-piece clamp assembly around riser and 2.

tighten clamp screws securely.

Tighten set screws securely.3.

Wall Bracket Installation:

Set Screws (2)

Clamp

Screws (2)

302840

3839

323334353637

9 8

015068-40

014209-40

002712-40

012443-40

002711-40

012442-40

011311-25

Faucet Body Assembly

Asm, Spindle - Hot

Hot Cartridge Only

Asm, Spindle - Cold

Cold Cartridge Only

Base Faucet Assembly

Base Faucet Asm w/ Cerama Cartridge

Cerama Cartridge w/ Check Valve, RTC

Base Faucet Assembly

011312-25

001638-45

000922-45

001661-45

001660-45

Cerama Cartridge w/ Check Valve, LTC

Handle, Lever - Blank

Screw, Handle

Index, Button - Hot (Red)

Index, Button - Cold (Blue)

45678

001019-45

00AA

014200-45

Washer

Asm, Coupling Flange

Lock Washer, EZ-Install

Riser Assembly

000369-40

EZ-K

N/A

001065-45

O-Ring, Swivel Piece

Nipple, 3/8” x 18”

Swivel Assembly

Swivel Piece

Riser Assembly, 18”

1112131415

010476-45

004R

B-0109-01

Asm, Finger Hook & Screw

Wall Bracket, 6” (add -B to model no. for wall bracket)

000821-40

000888-45

Spring, Body

Spring, Overhead

Pre-Rinse Assembly

161718

Pre-Rinse Unit

B-0044-H

B-0107

Asm, Flex Stainless Steel Hose

Asm, Spray Valve

Spray Valve Assembly

000907-45

Washer

Ring, Hold Down

Asm, Hold Down Ring & Washer

2021222324252627282930

000065-40

001120-45

003198-45

003199-45

Body, Spray Valve

Handle

Nut, Handle

Screw, Handle

000694-40

000019-40

007861-45

001121-45

Nipple

Cup, Spray

Ring, Sprayhead

Sprayface

***

000913-45

Screw, Sprayface

002856-40

Asm, Bonnet

313233343536373839

Bonnet Assembly

009306-20

012915-45

001040-45

000608-25

Stem

Washer, Seat

Washer, Bonnet Binding

Bonnet

***

000974-45

001100-45

000895-45

000753-25

012665-45

Washer, Bonnet Brass

Stem, Packing

Spring, Bonnet

Push Button

Grease Pack (O-Ring Lubricant)

***

* Parts included in B-10K parts kit