UK-ORBISECO-REV.00 (0218)
Orbis eco User Guide
THIS USER GUIDE SHOULD ALWAYS BE USED IN CONJUNCTION WITH THE USER MANUAL
1. Preparing the machine
2. Using the machine
Return the machine to the upright
position.
Fully unwind the supply cord from
the handle and plug into a
convenient socket outlet.
Adjust the handle to a
comfortable working position
using the handle lever.
If you have a duo machine, select the
speed you wish to operate at. Always
ensure the machine is switched off
before changing the speed setting.
Adjust the handle to an upright
position by turning the handle
lever on the side of the machine
and securing in position.
Pull the handle down until it rests
on the floor and the brush guard
is raised.
Fit the brush or drive board and
pad onto the drive plate and
rotate it anti-clockwise until
secure.
UK-ORBISECO-REV.00 (0218)
4. Scrubbing and shampooing
5. After use and storage
For storage switch off the
machine and unplug.
Remove the brush or drive board &
pad. Never store the machine with a
brush or drive board and pad fitted as
this can cause distortion, and results in
instability during operation.
Wrap the cable around the cable lever
ensuring that plug is not trailing on the
floor. Store the machine in a dry indoor
area only.
Fill the solution tank with mixed
water and approved chemical
according to the chemical
manufacturer’s instructions.
The flow of solution from the tank is
controlled by moving the left hand
lever. Releasing the lever stops the
solution. Proceed to operate the
machine in the normal manner,
releasing solution as required.
Use a wet & dry vac to pick up
the solution after.
Push the power button and then
press and hold the switch triggers
to start the machine. The switch
triggers must be held whilst using
the machine.
The normal movement of the
machine is from side to side across
the floor. Whilst it is engaged in the
normal working position, lower the
handle to move the machine to the
left. Raise the handle to move the
machine to the right.
To stop the machine release both
switch triggers.
Do not leave the machine
standing still or on a brush or
drive board and pad when not in
use.
Loading...