SECURITY PLUS-LINE
ALKCT-2000
ALKCT2000 ARM/DISARM REMOTE CONTROL
Item 71115 Version 1.0
Visit www.trust.com
for the latest instructions
USER MANUAL
MULTI LANGUAGE
2
4
1
3
On
O
Red LED indicator
On
O
ON button
4 sec
OFF button
Arm
O
Short press
ON button
5
6
Arm
O
ON button
4 sec
On
O
1.5 sec
O
On
OFF button
4 sec
On
O
1.5 sec
7 8
9
On
O
ON button
OFF button
4 sec
O
On
OFF button
Short press
OnOOn
O
ON button ON button
4 sec 4 sec
OFF button OFF button
O
On
OFF button
1 sec
10 11
On
O
1
ALKCT-2000 ARM/DISARM REMOTE CONTROL
1. Place battery
Open the battery slot at the back of the ALKCT by sliding it down. Place the included 3V CR2477 battery
and potentially the keychain cord. Close the battery slot. For more information on replacing and
purchasing new batteries visit trust.com/71115
2. LED indicator
Low battery: LED will blink 2x when a button is pushed
Confirm pair/unpair: LED will blink 5x
Successful arm/disarm: LED will light for 1.5 sec
Unsuccessful arm/disarm: LED will blink shortly 3x
3. Activate the pairing mode
Consult the manual of the Siren to activate the pairing mode. Put the ALKCT in pairing mode by first
pressing the ON and OFF button simultaneously for 4 sec (untill the LED of the ALKCT starts blinking).
4. Confirm pairing
After entering pairing mode press the ON button shortly to pair with the Siren. The LED indicator of the
Siren and ALKCT will be flashing 5 times to confirm that the pairing has been done successfully.
5. Arm/Turn on the siren
To arm the siren press the ON button for 4 seconds on the ALKCT.
If the siren is armed successfully the LED of the ALKCT will light up for 1.5 sec.
6. Disarm/Turn o the siren
To disarm the siren press the OFF button for 4 seconds on the ALKCT.
If the siren is disarmed successfully the LED of the ALKCT will light up for 1.5 sec.
7. Activating the unpairing mode
Consult the manual of the Siren to activate the pairing mode. Put the ALKCT in pairing mode by first
pressing the ON and OFF button simultaneously for 4 sec (untill the LED of the ALKCT starts blinking).
EN
ALKCT-2000 ARM/DISARM REMOTE CONTROL
2
8. Confirm unpairing
After entering pairing mode press the OFF button shortly to unpair with the Siren. The LED indicator of
the Siren and ALKCT will be flashing 5 times to confirm that the unpairing has been done successfully.
9. Delete ALKCT memory
To delete the memory of the ALKCT press the ON and OFF button simultaneously for 4 seconds (untill
the LED starts to blink) Release the buttons and press the ON and OFF buttons simultaneously again
for 4 seconds. (untill the LED starts to blink fast). Press the OFF button shortly to delete the memory of
the ALKCT. The LED will blink 5x to confirm the memory has been deleted.
10. Mounting the holder
Mount the holder of the ALKCT on a flat surface and secure it with screws. (Mounting screws not
included)
11. Place ALKCT in holder
When the holder has been mounted and secured with screws place the ALKCT in the holder. To place
the ALKCT slide it in from top to bottom.
EN
SECURITY PLUS-LINE
ALKCT-2000
ALKCT-2000 ARM/DISARM REMOTE CONTROL
Item 71115 Version 1.0
Visit www.trust.com
for the latest instructions
IMPORTANT INFORMATION
MULTI LANGUAGE
ALKCT-2000 ARM/DISARM REMOTE CONTROL
1
EN
Legal information
CE: Trust declares this device complies with the Directives as listed in Section 2 of this document.
WEEE: Dispose of the device at a recycling centre. More information: www.trust.com
Warranty information: www.trust.com/warranty
COMPATIBILITY
The remote control works with the ALSIR-2000.
FUNCTIONALITY
Arm/disarm remote control for enabling/disabling
ALSIR-2000.
TECHNICAL SPECIFICATIONS
• Battery
• Battery life
• Frequency
• RF range
• Battery low indication
1x 3V lithium batterij type CR2477 (included)
18 months stand-by
868 MHz 2-way communication
Up to 120 m (under optimal conditions)
LED will blink 2 times every time a button is pushed.
WIRELESS RADIO SIGNAL
• The 868 MHz signal passes through walls, windows and doors.
• Range up to 120 m (under optimal conditions).
• The strength depends on local conditions, such as the presence of metals. The metal particles in for example, double
glazing (HR glass), can provide a reduction in the range of wireless signals.
• There may be restrictions on the use of this device outside the EU. Check, if applicable, whether this device meets local
regulations.
Read the manual carefully. Faulty installation and usage will invalidate any warranty that may apply to this product.
SMARTPHONE/TABLET FUNCTIONS
By combining this product with a sensor and the OCTOPUS Control station, you can also set your alarm on / o via your
tablet and / or smartphone and receive push notifications when you are not at home.
for more information visit trust.com/71110
ALKCT-2000 ARM/DISARM REMOTE CONTROL
2
EN
BATTERY
Remove the battery from the device if it is not used for a
long time. Extreme temperatures reduce the capacity and
lifetime of the battery.
Replace the battery when the LED in the remote control
starts to blink 2 times every time a button is pushed.
Batteries should not be chopped into pieces or burned.
Dispose of batteries according to local regulations. Deliver
them for the possibility to reuse. Do not throw batteries
away with the normal household waste.
LIFE SUPPORT
Never use Trust SmartHome products for life support
systems or other applications where failures can have life-
threatening consequences.
INTERFERENCE
Interference can aect the operation of all
broadcast transmitters and receivers negatively. The
distance between 2 receivers or transmitters should be at
least 50 cm.
REPAIRS
Do not try to repair this product yourself. The device
contains no serviceable parts for the user.
WATER-RESISTANT
This product is not water-resistant.
CLEANING
Clean this product with a dry cloth. Do not use harsh
chemicals, cleaning solvents or strong detergents.
MEMORY
The remote control can save up to 8 devices in its memory.
HANDLING
Do not drop the device, bump the device against something
or shake it. Rough handling can damage internal circuit
boards and fine mechanics.
ENVIRONMENT
The product should not be exposed to extreme heat or
cold. This can damage the circuit boards and batteries or
shorten its life.
DISCLAIMER
This product is a basic deterrent against intruders.
However, it remains the responsibility of the end-user to
adequately protect their home against break-ins. Therefor
Trust cannot be held responsible or liable for any damages
resulting from break-ins, trespassing, unauthorized access
or vandalism.
ALKCT-2000 ARM/DISARM REMOTE CONTROL
50
Declaration of conformity
Trust International B.V. declares that the
TrusT smarThome
-product:
model: ALKCT-2000 Arm/Disarm remote control
item number: 71115
intended use: Indoor/Outdoor
is in compliance with the essential requirements and other relevant provisions of the following directives:
EMC Directive (2014/30/EU), Low Voltage Directive (2014/35/EU), ROHS Directive (2011/65/EC), R&T TE
Directive (1999/5/EC). The product is compatible with the following norms/standards:
Manufacturer/Authorised representative,
H. Donker, Procurement Director
Dordrecht, April 28 2016
EN
Trust International B.V.
LAAN VAN BARCELONA 600
3317DD DORDRECHT
NETHERLANDS
www.trust.com
EN 300-220-1 V2.4.1 (2012)
EN 300-220-2 V2.4.2 (2012)
EN 301489-1 V1.9.2 (2011)
EN 301489-3 V1.6.1 (2013)
EN 60950-1: 2006+A11: 2009+A1 2010+A12:
2011+A2 2013
EN 55014-1 : 2006+A1 : 2009+A2: 2011
EN 55014-2: 1997+A1: 2001 +A2: 2008
EN 50581: 2012
Loading...