Page 1
Aura Instruction Manual
030368-01 Issue 1.1 12/20
The Aura personal proximity sensor is designed to tackle the challenge of
social distancing by helping ensure a minimum distance.
To switch ON: PRESS and HOLD the button for 3 seconds - Blue LED lights up AND
button vibrates. The LED will ash blue every 3 seconds when unit is on. The unit will not turn
on when connected and charging.
3 SECS
To switch OFF: PRESS and HOLD the button for 3 seconds. The Blue LED will ash
twice.
3 SECS
When within two meters of another Aura the red LED will light and the Aura will vibrate and
sound an alert.
BLUE
BLUE
BLUE
RED
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Page 2
To charge: connect the unit using a Micro-USB charging cable. Charging takes approximately
1 hour. When charging, the LED ashes red. When fully charged, the LED is a steady red.
RED
RED
Aura can be used up to 12 hours on a single charge. When battery is low the LED will ash
red and device will vibrate every 1 minute.
When rst switched on, Aura doesn’t become
active until it is more than 2 meters away
from any other unit.
RED
For best results the face of Aura should be
worn on the outside of the wrist.
1 MIN
2.0m (6.5ft)
This device contains FCC ID: 2AQ33-DWM1004
This device complies with Part 15.107 and 15.109 Class B of the FCC Rules CFR47: October 2010.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
WARNING
CAUTION: CHOKING HAZARD - small parts.
Not suitable for children under 3 yrs.
Loading...