Caution : You must read this before you proceed
Club Chair
Page 1 OF 6
Label Picture Description QTY
A Chair 1
B Right Front Leg 1
C Left Front Leg 1
D Back Leg 2
Label Picture Description QTY
①
Bolt (M8*60MM) 9
②
Spring Washer 9
③
Washer 9
④
Allen Key 1
Page 2 OF 6
Before
Beginning
Assembly:
Chair(A)
Right Front Leg(B)
Left Front Leg(C)
Back Leg(D)
FRONT FACING
Page 3 OF 6
Step 1
Step 2
Insert the Right Back Leg(D) into the mounting position of Chair(A), and
attach using Bolts(①), Spring Washers(②) and Washers(③) with Allen
Key(④).
Repeat the same process to install the Left Back Leg(D).
After finish installing the Back Legs, use the same way to install the Right
Front Leg(B) and Left Front Leg(C).
Do not fully tighten the Bolts.
Place the Seat(A) on a clean, non-marring surface with the bottom facing
you, as shown in the picture above.
Carefully peel away the dust cover from the edge, and remove the Legs
and Hardware.
This Club Chair has multiple parts and may require up to 30 minutes to
assemble. To give you an overview of the Club Chair parts, the above
picture is to help you put the various parts into perspective. Please read
through the instructions below to familiarise yourself with the parts and
steps before assembly.
B
C
D
D
A
①
②
③
④
X9
X9
X9
Page 4 OF 6
Step 3
Step 4
Step 5
Place the Chair facedown onto a clean, non-marring surface as shown in
picture.
Put the Dust Cover back on the bottom of the Chair by smoothing down
the velcro at all four edges by hand.
Your Club Chair is ready for use.
This Club Chair can only be used on a flat, level surface.
Place the Chair on a LEVEL SURFACE to check for wobbles.
If it wobbles, press firmly down on both armrests at the same time. This
will help to ensure all Bolts and gaps reach full alignment status.
If no wobbles found, proceed to tighten all Bolts at all joints.
DO NOT fully tighten a Bolt in one go and then move on to the next.
Rather, in a sequential manner, gradually tighten each Bolt until all
Bolts are evenly secured.
This methodology will ensure maximum eveness once all Bolts are
fully tightened.
Page 5 OF 6
Page 6 OF 6
Loading...