True Refrigeration TUC-27FG, TUC and TWT, TUC-48F-D-4, TWT-44F-HD, TWT-60F Installation Manual

TRUE FOOD SERVICE EQUIPMENT, INC.
2001 East Terra Lane • O’Fallon, Missouri 63366-4434
(636)-240-2400 • FAX (636)272-2408 • INT’L FAX (636)272-7546 • (800)325-6152
Parts Department (800)424-TRUE • Parts Department FAX# (636)272-9471
INSTALLATION MANUAL FOR
UNDERCOUNTER FREEZERS & WORKTOP FREEZERS
TABLE OF CONTENTS
TUC-27FG
Safety Information
Safety Precautions 1 Proper Disposal 2 Connecting Electricity 3 Adapter Plugs 3
Installation / Operation Instructions
Ownership 4 Required Tools 4 Uncrating 4 Locating & Installation of Leg/Castors 5 Leveling Cabinet 6 Electrical Instructions 6 Start-up 7 Defrost Timer Instructions 8
TUC-48F-D-4
Wire Gauge Chart 9 Shelving Install/Operation & Light Switch 10
TWT-44F-HD
TWT-60F
Maintenance, Care & Cleaning
Cleaning Condenser Coil 11-12 Cabinet Cleaning 13-14 Warranty (U.S.A. & Canada Only!) 15
*Spanish, German, French and Dutch versions included.
CONGRATULATIONS!
You have just purchased the finest commercial
freezer available. You can expect many years of
trouble-free operation.
UNDERCOUNTER &
WORKTOP FREEZERS
............ www.truemfg.com ............
6/11/10 - 500 SB #912633
True Food Service Equipment, Inc.
............ www.truemfg.com ............
True Food Service Equipment, Inc.
SAFETY INFORMATION
How to Maintain Your
Freezer to Receive the Most
Efficient and Successful Operation
You have selected one of the  nest commercial freezer units made. It is
manufactured under strict quality controls with only the best quality materials
available. Your TRUE freezer when properly maintained will give you many
years of trouble-free service.
WARNING!
Use this appliance for its intended purpose as described in
this Owner Manual.
This cabinet contains fluorinated greenhouse gas covered by the Kyoto Protocol
(please refer to cabinet’s inner label for type and volume,
GWP of 134a= 1,300. R404a= 3,800).
SAFETY PRECAUTIONS
When using electrical appliances, basic safety precautions should be followed, including the following:
This freezer must be properly installed and
located in accordance with the Installation Instructions before it is used.
Do not allow children to climb, stand or hang
on the shelves in the freezer. They could damage the freezer and seriously injure themselves.
Do not touch the cold surfaces in the freezer
compartment when hands are damp or wet. Skin may stick to these extremely cold surfaces.
NOTE: We strongly recommend that any servicing be performed by a quali ed individual.
Unplug the freezer before cleaning and making repairs.
Setting temperature controls to the 0 position
does not remove power to the evaporator fans.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other appliance.
Keep fingers out of the “pinch point” areas;
clearances between the doors and between the doors and cabinet are necessarily small; be careful closing doors when children are in the area.
1
............ www.truemfg.com ............
1
True Food Service Equipment, Inc.
SAFETY INFORMATION
DANGER!
RISK OF CHILD ENTRAPMENT
PROPER DISPOSAL OF THE FREEZER
Child entrapment and suffocation are not problems of the past. Junked or abandoned freezer are still dangerous… even if they will sit for “just a few days.” If you are getting rid of your old freezer, please follow the instructions below to help prevent accidents.
Before You Throw Away Your Old Refrigerator or Freezer:
Take off the doors.
Leave the shelves in place so that children may
not easily climb inside.
Refrigerant Disposal
Your old refrigerator may have a cooling system that uses “Ozone Depleting ” chemicals. If you are throwing away your old refrigerator, make sure the refrigerant is removed for proper disposal by a qualified service technician. If you intentionally release any refrigerants you can be subject to fines and imprisonment under provisions of the environmental regulations.
USE OF EXTENSION CORDS
NEVER USE AN EXTENSION CORD! TRUE will not warranty any refrigerator that has been connected to an extension cord.
2 2
............ www.truemfg.com ............
True Food Service Equipment, Inc.
SAFETY INFORMATION
WARNING!
HOW TO CONNECT ELECTRICITY
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord. For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazard from this appliance.
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
If the outlet is a standard 2-prong outlet, it is your personal responsibility and obligation to have it replaced with the properly grounded 3-prong wall outlet.
The freezer should always be plugged into it’s own individual electrical circuit, which has a voltage rating that matches the rating plate.
This provides the best performance and also prevents overloading building wiring circuits which could cause a fire hazard from overheated wires.
Never unplug your freezer by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.
Repair or replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When removing the freezer away from the wall, be careful not to roll over or damage the power cord.
USE OF ADAPTER PLUGS
NEVER USE AN ADAPTER PLUG! Because of potential safety hazards under certain conditions, we strongly recommend against the use of an adapter plug.
(North America Use Only!)
NEMA plugs
TRUE uses these types of plugs.
If you do not have the right outlet
have a certified electrician install
the correct power source.
3
............ www.truemfg.com ............
3
True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION / OPERATION INSTRUCTIONS OWNERSHIP
To insure that your unit works properly from the first day, it must be installed properly. We highly recommend a trained refrigeration mechanic and electrician install your True equipment. The cost of a professional installation is money well spent.
Before you start to install your True unit, carefully inspect it for freight damage. If damage is discovered, immediately file a claim with the delivery freight carrier.
True is not responsible for damage incurred during shipment.
REQUIRED TOOLS
Adjustable Wrench
Phillips Head Screwdriver
Level
UNCRATING
The following procedure is recommended for uncrating the unit:
A. Remove the outer packaging, (cardboard
and bubbles or styrofoam corners and clear plastic). Inspect for concealed damage. Again, immediately file a claim with the freight carrier if there is damage.
B. Move your unit as close to the final location as
possible before removing the wooden skid.
C. Remove door bracket on swing glass door
models (see image 1-2).
Note: Keys for coolers with door locks are located in warranty packets.
1
2
Glass Door Models Only.
REMOTE UNITS (This section applies to remotes only!)
• Remote cabinets must be ordered as remote. We do not recommend converting for a standard self contained to remote system.
• All remote cabinets must be hard wired.
• No castors available.
• All remote cabinets come standard using 404A refrigerant.
• All remote units come standard with expansion valve, liquid line solenoid, heated condensate pan, and defrost timer when applicable.
4 4
............ www.truemfg.com ............
• Contact True Technical Service for BTU requirements.
• No wiring necessary between cabinet and condensing unit.
• All remote condensing units purchased from True are 208/230 volts single phase.
If you have any questions regarding this section, please call True at 1-(800)-325-6152.
Loading...
+ 11 hidden pages