True Refrigeration TUC-27G, TSSU-48-10, TPP-67D-2 Installation Manual

TRUE FOOD SERVICE EQUIPMENT, INC.

2001 East Terra Lane • O’Fallon, Missouri 63366-4434

(636)-240-2400 • FAX [phone] • INT’L FAX [phone] • [phone]

Parts Department (800)424-TRUE • Parts Department FAX# [phone]

INSTALLATION MANUAL FOR UNDERCOUNTERS,

WORKTOPS, SANDWICH/SALAD & PIZZA PREP

TABLE OF CONTENTS

TUC-27G

Safety Information

Safety Precautions 1
Proper Disposal 2
Connecting Electricity 3
Adapter Plugs 3

TSSU-48-10

TUC-60D-4

TPP-67D-2

TWT-93

Installation / Operation Instructions

Ownership 4
Required Tools 4
Uncrating 4
Locating & Installation of Leg/Castors 5
Pizza Prep Tables 6
Installing TSSU Hood Cover 6
Leveling Cabinet 7
Electrical Instructions 7
Wire Gauge Chart 8
Start-up 9
Cabinet Air-Flow 9
Temperature Control Adjustment 10
TSSU-27-12M-C Chiller Hose 11
Shelving Install/Operation & Light Switch 12

Maintenance, Care & Cleaning

Cleaning Condenser Coil 13-14
Stainless Steel Equipment Care & Cleaning 15-16
Composite Cutting Board Maintenance 16
Warranty (U.S.A. & Canada Only!) 17

*Spanish, German, French, and Dutch versions included.

CONGRATULATIONS!

You have just purchased the finest commercial

refrigerator available. You can expect many years of

trouble-free operation.

TPP-93D-6

UNDERCOUNTERS, WORKTOPS,

SANDWICH/SALAD & PIZZA PREP

............ www.truemfg.com ............

#897003 • WP-30

True Food Service Equipment, Inc.

............ www.truemfg.com ............

True Food Service Equipment, Inc.

SAFETY INFORMATION

How to Maintain Your Unit to

Receive the Most Efficient and

Successful Operation

You have selected one of the finest commercial refrigeration units made. It is manufactured

under strict quality controls with only the best quality materials available. Your TRUE cooler

when properly maintained will give you many years of trouble-free service.

WARNING!

Use this appliance for its intended purpose as described in

this Owner Manual.

This cabinet contains fluorinated greenhouse gas covered by the Kyoto Protocol

(please refer to cabinet’s inner label for type and volume,

GWP of 134a= 1,300. R404a= 3,800).

SAFETY PRECAUTIONS

When using electrical appliances, basic safety precautions should be followed, including the following:

• This refrigerator must be properly installed
and located in accordance with the Installation
Instructions before it is used.

• Do not allow children to climb, stand or hang
on the shelves in the refrigerator. They could
damage the refrigerator and seriously injure
themselves.

• Do not touch the cold surfaces in the
refrigerator compartment when hands are damp
or wet. Skin may stick to these extremely cold
surfaces.

• Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.

NOTE: We strongly recommend that any servicing be
preformed by a qualified individual.

• Unplug the refrigerator before cleaning and
making repairs.

• Setting temperature controls to the 0 position
does not remove power.

• Keep fingers out of the “pinch point” areas;
clearances between the doors and between
the doors and cabinet are necessarily small; be
careful closing doors when children are in the
area.

............ www.truemfg.com ............

11

True Food Service Equipment, Inc.

SAFETY INFORMATION

DANGER!

RISK OF CHILD ENTRAPMENT

PROPER DISPOSAL OF THE REFRIGERATOR

Child entrapment and suffocation are not problems
of the past. Junked or abandoned refrigerators are
still dangerous… even if they will sit for “just a few
days.” If you are getting rid of your old refrigerator,
please follow the instructions below to help pre­vent accidents.

Before You Throw Away Your Old Refrigerator or
Freezer:

• Take off the doors.

• Leave the shelves in place so that children may
not easily climb inside.

Refrigerant Disposal

Your old refrigerator may have a cooling system
that uses “Ozone Depleting ” chemicals. If you are
throwing away your old refrigerator, make sure the
refrigerant is removed for proper disposal by a
qualified service technician. If you intentionally
release any refrigerants you can be subject to
fines and imprisonment under provisions of the
environmental regulations.

USE OF EXTENSION CORDS

NEVER USE AN EXTENSION CORD! TRUE will not warranty any refrigerator that has been connected to an extension cord.

............ www.truemfg.com ............

22

True Food Service Equipment, Inc.

SAFETY INFORMATION

WARNING!

HOW TO CONNECT ELECTRICITY

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.

The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard
from this appliance.

Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.

If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with the properly grounded 3-prong wall
outlet.

The refrigerator should always be plugged into
it’s own individual electrical circuit, which has a
voltage rating that matches the rating plate.

This provides the best performance and also
prevents overloading building wiring circuits which

could cause a fire hazard from overheated wires.

Never unplug your refrigerator by pulling on the
power cord. Always grip plug firmly and pull
straight out from the outlet.

Repair or replace immediately all power cords that
have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage
along its length or at either end.

When removing the refrigerator away from the
wall, be careful not to roll over or damage the
power cord.

USE OF ADAPTER PLUGS

NEVER USE AN ADAPTER PLUG! Because of potential safety hazards under certain conditions, we strongly recommend
against the use of an adapter plug.

(North America Use Only!)

NEMA plugs

TRUE uses these types of plugs.

If you do not have the right outlet

have a certified electrician install

the correct power source.

............ www.truemfg.com ............

33

True Food Service Equipment, Inc.

INSTALLATION / OPERATION INSTRUCTIONS

INSTALLATION / OPERATION INSTRUCTIONS

OWNERSHIP

To insure that your unit works properly from the
first day, it must be installed properly. We highly
recommend a trained refrigeration mechanic and
electrician install your TRUE equipment. The cost
of a professional installation is money well spent.

Before you start to install your TRUE unit,
carefully inspect it for freight damage. If damage
is discovered, immediately file a claim with the
delivery freight carrier.

TRUE is not responsible for damage incurred during
shipment.

REQUIRED TOOLS

• Adjustable Wrench

• Phillips Head Screwdriver

• Level

UNCRATING

The following procedure is recommended for
uncrating the unit:

A. Remove the outer packaging, (cardboard

and bubbles or styrofoam corners and clear
plastic). Inspect for concealed damage. Again,
immediately file a claim with the freight carrier
if there is damage.

B. Move your unit as close to the final location as

possible before removing the wooden skid.

C. Remove door bracket on swing glass door

models (see image 1-2).

Note: Keys for coolers with door locks are located in
warranty packets.

REMOTE UNITS (This section applies to
remotes only!)

• Remote cabinets must be ordered as remote.
We do not recommend converting for a standard
self contained to remote system.

• All remote cabinets must be hard wired.

• No castors available.

• All remote cabinets come standard using 404A
refrigerant.

• All remote units come standard with expansion
valve, liquid line solenoid, heated condensate
pan, and defrost timer when applicable.

1

2

Glass Door Models Only.

• Contact TRUE Technical Service for BTU
requirements.

• No wiring necessary between cabinet and
condensing unit.

• All remote condensing units purchased from
TRUE are 208/230 volts single phase.

If you have any questions regarding this section, please
call TRUE at 1-(800)-325-6152.

............ www.truemfg.com ............

44