True Manufacturing Company T-35 User Manual

T-23

TRUE FOOD SERVICE EQUIPMENT, INC.

2001 East Terra Lane • P.O. Box 970 • O’Fallon, Missouri 63366

(636)-240-2400 • FAX [phone] • INT’L FAX [phone] • [phone]

Parts Department (800)424-TRUE • Parts Department FAX# [phone]

INSTALLATION MANUAL FOR T-SERIES FREEZER /

REFRIGERATOR (SWING AND SLIDE DOOR)

TABLE OF CONTENTS

Safety Information

Safety Precautions 1
TSD Do’s and Don’ts 2
Proper Disposal 3
Connecting Electricity 4
Adapter Plugs 4

Installation / Operation Instructions

Ownership 5
Required Tools 5
Uncrating 5
Leveling Cabinet 6
Installation of Castors or Optional Legs 7
Installing Optional Castors on a T-12FG 8
Wire Gauge Chart 9
Sealing Cabinet to Floor & Electrical Inst. 10
Start-up 11

T-35

Shelving Install/Operation & Light Switches 12
Grasslin Defrost Timer (Freezer Units Only) 13
Field Troubleshooting (Freezer Units Only) 14-15
Light Cover Install for T-12FG 16

Maintenance, Care & Cleaning

Cleaning Condenser Coil 17-18
Temperature Control Adjustment 19
Stainless Steel Equipment Care & Cleaning 20-21

TSD-47G

TSD-69

Light Bulb Replacement 21
Warranty (U.S.A. & CANADA ONLY!) 22

*Spanish, German, French, Dutch, and Arabic versions included.

CONGRATULATIONS!

You have just purchased the finest commercial

freezer / refrigerator available. You can expect many

years of trouble-free operation.

T-SERIES

FREEZER / REFRIGERATOR SWING

& SLIDE DOOR

............ www.truemfg.com ............

11/12/08 -20K SB #897001

True Food Service Equipment, Inc.

............ www.truemfg.com ............

True Food Service Equipment, Inc.

SAFETY INFORMATION

How to Maintain Your Freezer

/ Refrigerator to Receive the Most

Efficient and Successful Operation

You have selected one of the finest commercial refrigeration units made. It is

manufactured under strict quality controls with only the best quality materials

available. Your TRUE cooler when properly maintained will give you many

years of trouble-free service.

WARNING!

Use this appliance for its intended purpose as described

in this Owner Manual.

SAFETY PRECAUTIONS

When using electrical appliances, basic safety precautions should be followed, including the following:

This refrigerator must be properly installed and

located in accordance with the Installation
Instructions before it is used.

Do not allow children to climb, stand or hang

on the shelves in the refrigerator. They could
damage the refrigerator and seriously injure
themselves.

Do not touch the cold surfaces in the freezer

compartment when hands are damp or wet.
Skin may stick to these extremely cold surfaces.

Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any
other appliance.

Keep fingers out of the “pinch point” areas;

clearances between the doors and between the
doors and cabinet are necessarily small; be
careful closing doors when children are in the
area.

NOTE: We strongly recommend that any
servicing be performed by a qualified
individual.

Unplug the refrigerator before cleaning and
making repairs.

Setting temperature controls to the 0 position

does not remove power to the light circuit,
perimeter heaters, or evaporator fans.

1

............ www.truemfg.com ............

1

True Food Service Equipment, Inc.

SAFETY INFORMATION

2 2

............ www.truemfg.com ............

True Food Service Equipment, Inc.

SAFETY INFORMATION

DANGER!

RISK OF CHILD ENTRAPMENT

PROPER DISPOSAL OF THE FREEZER /
REFRIGERATOR

Child entrapment and suffocation are not problems
of the past. Junked or abandoned refrigerators are
still dangerous… even if they will sit for “just a few
days.” If you are getting rid of your old refrigerator,
please follow the instructions below to help
prevent accidents.

Before You Throw Away Your Old Refrigerator
or Freezer:

Take off the doors.

Leave the shelves in place so that children may

not easily climb inside.

Refrigerant Disposal

Your old refrigerator may have a cooling system
that uses “Ozone Depleting ” chemicals. If you are
throwing away your old refrigerator, make sure the
refrigerant is removed for proper disposal by a
qualified service technician. If you intentionally
release any refrigerants you can be subject to
fines and imprisonment under provisions of the
environmental regulations.

USE OF EXTENSION CORDS

NEVER USE AN EXTENSION CORD! TRUE will not warranty any refrigerator that has been
connected to an extension cord.

3 3

............ www.truemfg.com ............

True Food Service Equipment, Inc.

SAFETY INFORMATION

WARNING!

HOW TO CONNECT ELECTRICITY

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.

The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard
from this appliance.

Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.

If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with the properly grounded 3-prong wall
outlet.

The refrigerator should always be plugged into
it’s own individual electrical circuit, which has a
voltage rating that matches the rating plate.

This provides the best performance and also
prevents overloading building wiring circuits which
could cause a fire hazard from overheated wires.

Never unplug your refrigerator by pulling on the
power cord. Always grip plug firmly and pull
straight out from the outlet.

Repair or replace immediately all power cords that
have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage
along its length or at either end.

When removing the refrigerator away from the
wall, be careful not to roll over or damage the
power cord.

USE OF ADAPTER PLUGS

NEVER USE AN ADAPTER PLUG! Because of potential safety hazards under certain conditions, we
strongly recommend against the use of an adapter plug.

(North America Use Only!)

NEMA plugs

TRUE uses these types of plugs.

If you do not have the right outlet

have a certified electrician install

the correct power source.

4

............ www.truemfg.com ............

4

True Food Service Equipment, Inc.

INSTALLATION / OPERATION INSTRUCTIONS

INSTALLATION / OPERATION INSTRUCTIONS
OWNERSHIP

To insure that your unit works properly from the
first day, it must be installed properly. We highly
recommend a trained refrigeration mechanic and
electrician install your True equipment. The cost
of a professional installation is money well spent.

Before you start to install your True unit,
carefully inspect it for freight damage. If damage
is discovered, immediately file a claim with the
delivery freight carrier.

True is not responsible for damage incurred
during shipment.

REQUIRED TOOLS

Adjustable Wrench

Phillips Head Screwdriver

Level

UNCRATING

NOTE:

Units with a solar thermometer will experience a 15

second delay after exposed to light before it reads the

proper temperature.

The following procedure is recommended for uncrating
the unit:

A. Remove the outer packaging, (cardboard and

bubbles or styrofoam corners and clear plastic).
Inspect for concealed damage. Again, immediately
file a claim with the freight carrier if there is
damage.

B. Move your unit as close to the final location as

possible before removing the wooden skid.

C. Remove door bracket on swinging glass door models

(see image 1-2). Sliding glass door models contain
shipping blocks (three for each door). Remove
the two styrofoam blocks taped to the top of the
door tracks (see image 3). The shipping blocks
are orange in color and by opening the door a little
the blocks can be removed (see images 4-6). Do
not throw the bracket or blocks away. For future
cabinet movement the bracket and blocks will need
to be installed so the glass door does not receive any
damage. (See image for bracket and shipping block
removal)

Note: Keys for coolers with door locks are located in
warranty packets

.

1 2 3

4

5 5

............ www.truemfg.com ............

5

6

True Food Service Equipment, Inc.

INSTALLATION / OPERATION INSTRUCTIONS

LOCATING

A. Place packing material behind cabinet as a

cushion. Carefully lay the unit on its back to

remove skid.

When lifting unit remember to

leave the cabinet upright for 24 hours before

plugging into power source.

B. Remove skid by unscrewing all base rail anchor

brackets. Place skid to the side.

C. Carefully lift cabinet upright.

LEVELING

A. Set unit in its final location. Be sure there is
adequate ventilation in your room. Under extreme heat
conditions, (100°F+, 38°C+), you may want to install an
exhaust fan.

Warning

Warranty is void if ventilation is insufficient.

B. Proper leveling of your True cooler is critical to
operating success (for non-mobile models). Effective
condensate removal and door operation will be effected
by leveling.

C. The cooler should be leveled front to back and side
to side with a level.

D. Ensure that the drain hose or hoses are positioned in
the pan.

E. Free plug and cord from inside the lower rear of the
cooler (do not plug in).

F. The unit should be placed close enough to the
electrical supply so that extension cords are never used.

Removing

skid from

bottom of

cabinet.

Some units have a

polyester strap that

secures the cabinet to

the shipping skid. Cut

this polyester strap

and remove the

wood skid.

Polyester Strap

Warning

Compressor warranties are void if the unit is more
than 7 ft. (2.1m) from plug-in connection.

P

REMOTE UNITS (This section applies to
remotes only!)

• Remote cabinets must be ordered as remote.
We do not recommend converting from a
standard self contained to remote system.

• All remote cabinets must be hard wired.

• No castors available.

• All remote cabinets come standard using 404A
refrigerant.

• All remote units come standard with expansion
valve, liquid line solenoid, heated condensate
pan, and defrost timer when applicable.

6

............ www.truemfg.com ............

• Contact True Technical Service for BTU
requirements.

• No wiring necessary between cabinet and
condensing unit.

• All remote condensing units purchased from
True are 208/230 volts single phase.

If you have any questions regarding this
section, please call True at 1-(800)-325-6152.

6