TROY Group 3015 Installation Guide

Installation Guide

Hewlett-Packard 3015 Printers:

IMPORTANT: Ensure the printer power is switched OFF,

and then disconnect the printer power cord
from the AC outlet.

1. Slide the right-side rear panel toward the rear of the printer.

Figure 1

2. Insert the font card into the rear USB slot (slot nearest the interior of the printer). Ensure the font card is

fully inserted in the card slot.

Figure 2

3. Replace the printer panel. Then reconnect the printer power cord and printer data cable.

4. Refer to the TROY Quick-Start Guide (provided with your TROY Font Card Solution) for instructions on

installing the required TROY software and support files.

NOTE: If assistance is required for installing the font card, please call TROY Technical Support

at [phone]. Customers outside the United States, please call [phone].

Document #50-70417-001 Rev. A Page 1 of 1