Troy-Bilt 12AI836 Series Fast Start Manual
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
A
(A) Lift handle
B
to extended
position.
(B) Tighten star
knobs.
B
1
Blade Control
Handle
Star Knobs
Starter
Rope
3
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
slip starter
rope into rope
guide.
(D) Tighten
rope guide
wing knob.
A
B
D
C
12AI836 © 2007
Place ends of
lower handle
onto handle
brackets.
Tighten star
knobs.
2
Refer to Operator’s Manual for instructions on attaching the grass catcher.
4
Use cable
tie to secure
cables to
lower handle.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
778-11501
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2-inch of
top of tank.
5
7
Oil Fill
Depress blade control handle and hold.
Gas Cap
Fill engine with entire contents of oil bottle
supplied.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
Need Help?
Need Help?
6
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Call 1-888-TO-HELP-U
Call 1-888-TO-HELP-U
8
Pull starter rope with quick, full arm stroke.
If engine does not start after ten seconds of
repeated pulls, wait a few minutes and repeat
steps 7 through 8.
Loading...