Troy-Bilt 11a-bobl.765, 11A-B0BL765 Quick Start Manual
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
A. Remove the wing nuts and carriage bolts
1
B. Remove T-bolts from
the handle brackets.
securing the upper handle to the lower
handle.
A
2
A
B
Pivot the upper handle
upward.
A. Insert the T-bolts removed in Step 1B
through the handle brackets to secure
the handle in place.
B. Secure upper handle
to lower handle with
B
B
Blade Control Handle
wing nuts (on outside)
and carriage bolts
removed Step 1A.
4
A
Starter
Rope Handle
Wing Nuts
T-Bolts
A
B
D
5
3
A. Pull upward on
the handle until
the holes in lower
handle line up
with the holes
in the handle
bracket.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
C
A. Hold blade control handle against upper handle.
B. Slowly pull starter rope handle from engine and
slip starter rope into the rope guide.
C. Tighten rope guide wing knob.
D. Use cable tie to secure cables to lower handle.
778-12364A© 2013 11A-B06
Need Help? Call 1-888-TO-HELP-U
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
6
Pour the entire contents of the oil bottle (supplied)
into the oil fill. Check the oil level using the
dipstick. (Refer to the Operator’s Manual)
7
Gas Fill
Primer
8
3
Push the primer three times.
9
Fill fuel tank with clean, fresh gasoline. Do not
fill above the base of fuel tank neck.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Oil Fill /
Dipstick
While standing behind the machine, pivot the Blade
Control Handle against the upper handle.
Grasp the starter rope handle and pull with quick, fullarm stroke. If the engine does not start after five pulls,
repeat steps 8 and 9.
778-12364A© 2013 11A-B06
Need Help? Call 1-888-TO-HELP-U
Loading...