Trotec PCPS 10-16V operation manual
PCPS 10-16V / PCPS 11-16V
EN
ORIGINAL INSTRUCTIONS
CORDLESS COMPRESSOR AND
CORDLESS AIR PUMP
TRT-BA-PCPS10-16V-PCPS11-16V-TC-002-EN
Table of contents
Notes regarding the instructions ..........................................1
Safety .....................................................................................1
Information about the device................................................5
Transport and storage...........................................................7
Start-up..................................................................................8
Operation .............................................................................11
You can download the current version of the operating manual
and the EU declaration of conformity via the following link:
PCPS 10-16V
PCPS 11-16V
https://hub.trotec.com/?id=41512
Available accessories..........................................................13
Errors and faults..................................................................13
Maintenance ........................................................................14
Disposal ...............................................................................15
Declaration of conformity ...................................................15
Notes regarding the instructions
Symbols
Warning of electrical voltage
This symbol indicates dangers to the life and health of
persons due to electrical voltage.
Warning
This signal word indicates a hazard with an average
risk level which, if not avoided, can result in serious
injury or death.
Safety
Read this manual carefully before starting or using the
device. Always store the manual in the immediate vicinity
of the device or its site of use!
Warning
Observe all the safety warnings, instructions,
illustrations and technical data provided with this
power tool.
Failure to follow the instructions below may result in
electric shock, fire and/ or serious injury.
Save all warnings and instructions for future
reference.
The term power tool used in the safety warnings refers to both
mains-operated and battery-powered electric tools (with/
without power cable).
Caution
This signal word indicates a hazard with a low risk
level which, if not avoided, can result in minor or
moderate injury.
Note
This signal word indicates important information (e.g.
material damage), but does not indicate hazards.
Info
Information marked with this symbol helps you to carry
out your tasks quickly and safely.
Follow the manual
Information marked with this symbol indicates that the
operating manual must be observed.
Wear hearing protection
Information marked with this symbol indicates that you
should wear hearing protection.
1 EN
cordless compressor and cordless air pump PCPS 10-16V / PCPS 11-16V
General Power Tool Safety Warnings – Work area
safety
General Power Tool Safety Warnings – Personal
safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust
or fumes.
• Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control.
General Power Tool Safety Warnings – Electrical
safety
• Power tool plugs must match the outlet. Never modify
the plug in any way. Do not use any adapter plugs with
earthed (grounded) power tools. Unmodified plugs and
matching outlets will reduce risk of electric shock.
• Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators.
There is an increased risk of electric shock if your body is
earthed or grounded.
• Do not expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
• Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep the cord
away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric
shock.
• When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
• If operating a power tool in a damp location is
unavoidable, use a residual current device(RCD)
protected supply. Use of an RCD reduces the risk of
electric shock.
• Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a
power tool while you are tired or under the influence of
drugs, alcohol or medication. A moment of inattention
while operating power tools may result in serious personal
injury.
Use personal protective equipment. Always
wear eye protection. Protective equipment such
as dust mask, non-skid safety shoes, hard hat, or
hearing protection used for appropriate conditions
will reduce personal injuries.
• Prevent unintentional starting. Ensure the switch is in
the off-position before connecting to power source
and/or battery pack, picking up or carrying the tool.
Carrying power tools with your finger on the switch or
energising power tools that have the switch on invites
accidents.
• Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to a
rotating part of the power tool may result in personal
injury.
• Do not overreach. Keep proper footing and balance at
all times. This enables better control of the power tool in
unexpected situations.
• Dress properly. Do not wear loose clothing or
jewellery. Keep your hair and clothing away from
moving parts. Loose clothes, jewellery or long hair can be
caught in moving parts.
• If devices are provided for the connection of dust
extraction and collection facilities, ensure these are
connected and properly used. The use of a dust
extraction system may reduce dust-related hazards.
• Do not let familiarity gained from frequent use of tools
allow you to become complacent and ignore tool
safety principles. A careless action can cause severe
injury within a fraction of a second.
EN 2
cordless compressor and cordless air pump PCPS 10-16V / PCPS 11-16V
General Power Tool Safety Warnings – Power tool
use and care
General Power Tool Safety Warnings – Battery tool
use and care
• Do not force the power tool. Use the correct power tool
for your application. The correct power tool will do the
job better and safer at the rate for which it was designed.
• Do not use the power tool if the switch does not turn it
on and off. Any power tool that cannot be controlled with
the switch is dangerous and must be repaired.
• Disconnect the plug from the power source and / or
the battery pack, if detachable, from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such preventive
safety measures reduce the risk of starting the power tool
accidentally.
• Store idle power tools out of the reach of children and
do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
• Maintain power tools and accessories carefully. Check
for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool’s operation. If damaged, have the power
tool repaired before use. Many accidents are caused by
poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly maintained
cutting tools with sharp cutting edges are less likely to
bind and are easier to control.
• Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into
account the working conditions and the work to be
performed. Use of the power tool for operations different
from those intended could result in a hazardous situation.
• Keep handles and gripping surfaces dry, clean and
free from oil and grease. Slippery handles and gripping
surfaces do not allow for safe handling and control of the
tool in unexpected situations.
• Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
• Use power tools only with specifically designated
battery packs. Use of any other battery packs may create
a risk of injury and fire.
• When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys, nails,
screws or other small metal objects, that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
• Under abusive conditions, liquid may be ejected from
the battery. Avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
• Do not use a damaged or modified battery. Damaged or
modified batteries can behave unexpectedly and lead to
fires, explosions or injuries.
• Do not expose a battery to fire or excessively high
temperatures. Exposure to fire or temperatures above
130°C (265°F) may cause an explosion.
• Follow all the instructions for charging and never
charge the battery or the cordless tool outside the
temperature range specified in the operating
instructions. Incorrect charging or charging outside of the
permissible temperature range can destroy the battery and
increase the risk of fire.
General Power Tool Safety Warnings – Service
• Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
• Never service damaged battery packs. Service of
battery packs should only be performed by the
manufacturer or authorized service providers.
3 EN
cordless compressor and cordless air pump PCPS 10-16V / PCPS 11-16V
Intended use
Only use the device PCPS 10-16V:
• for inflating car tyres, bicycle tyres, inflatable toys, sports
equipment and beach items
• measuring the current pressure level of an inflatable object
whilst adhering to the technical data.
Info
Please note that the pressure gauge is not calibrated.
Only use the device PCPS 11-16V:
• for inflating and deflating common inflatables with a large
volume such as air mattresses, swimming pools, rubber
dinghies or camping equipment
whilst adhering to the technical data.
We recommend using the power tool with original Trotec
accessories.
Improper use
The device PCPS 11-16V is not intended for inflating bicycle or
car tyres.
Personnel qualifications
People who use this device must:
• have read and understood the operating manual, especially
the Safety chapter.
Personal protective equipment
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
Warning of explosive substances
Do not expose the battery to temperatures above
45 °C! Do not let the battery come into contact with
water or fire! Avoid direct sunlight and moisture. There
is a risk of explosion!
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Caution
Keep a sufficient distance from heat sources.
Wear hearing protection.
Excessive noise can lead to hearing loss.
Residual risks
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket and the battery from the device!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Note
The device is not suitable for continuous operation. To
prevent overheating, the device must not be used nonstop for more than 10minutes(PCPS 10-16V) or
20minutes(PCPS 11-16V).
Should the device be overheating nonetheless, remove
the battery.
Allow the device to cool down sufficiently before
switching it back on.
EN 4
cordless compressor and cordless air pump PCPS 10-16V / PCPS 11-16V
Information about the device
1
3
2
4
3
9
8
7
6
5
10
11
15
14
13
12
Device description
The cordless compressor PCPS 10-16V is suited for blowing up
bicycle tyres, car tyres as well as inflatables toys or sports
equipment such as footballs.
The device is equipped with an integrated pressure gauge.
Upon reaching the desired pressure value, the device will be
switched off automatically.
The cordless air pump PCPS 11-16V is suited for inflating and
deflating inflatable products with a large volume such as air
mattresses or rubber dinghies.
Device depiction
Cordless compressor PCPS 10-16V
No. Designation
1 Mount for valve adapters
2 Handle
3 Air inlet
4 Mount for compressed-air hose
5 Control panel
6 Battery holder
7 On/off switch
8 LED work lamp
9 Union nut
Cordless air pump PCPS 11-16V
No. Designation
10 Air inlet (deflating)
11 Handle
12 Battery holder
13 On/off switch
14 LED work lamp
15 Air outlet (inflating)
5 EN
cordless compressor and cordless air pump PCPS 10-16V / PCPS 11-16V
Loading...