Declaration of conformity ...................................................22
Notes regarding the instructions
Symbols
Warning of electrical voltage
This symbol indicates dangers to the life and health of
persons due to electrical voltage.
DH 15
https://hub.trotec.com/?id=42978
DH 30
https://hub.trotec.com/?id=42979
DH 60
https://hub.trotec.com/?id=42980
Safety
Warning
This signal word indicates a hazard with an average
risk level which, if not avoided, can result in serious
injury or death.
Caution
This signal word indicates a hazard with a low risk
level which, if not avoided, can result in minor or
moderate injury.
Note
This signal word indicates important information
(e.g. material damage), but does not indicate hazards.
Info
Information marked with this symbol helps you to carry
out your tasks quickly and safely.
Follow the manual
Information marked with this symbol indicates that the
instructions must be observed.
Read this manual carefully before starting or using the
device. Always store the manual in the immediate vicinity
of the device or its site of use!
Warning
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/ or serious injury.
Save all warnings and instructions for future
reference.
This appliance can be used by children aged from
8years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children
without supervision.
•Do not use the device in potentially explosive rooms.
•Do not use the device in aggressive atmosphere.
•Let the device dry out after a wet clean. Do not operate it
when wet.
•Do not use the device with wet or damp hands.
2EN
dehumidifier DH 15 / DH 30 / DH 60
•Do not expose the device to directly squirting water.
•Never insert any objects or limbs into the device.
•Do not cover or transport the device during operation.
•Do not sit on the device.
•This appliance is not a toy! Keep away from children and
animals. Do not leave the device unattended during
operation.
•Check accessories and connection parts for possible
damage prior to every use of the device. Do not use any
defective devices or device parts.
•Ensure that all electric cables outside of the device are
protected from damage (e.g. caused by animals). Never
use the device if electric cables or the power connection
are damaged!
•The electrical connection must correspond to the
specifications in chapter Technical data.
•Insert the mains plug into a properly secured mains
socket.
•Observe the device's power input, cable length and
intended use when selecting extensions to the power
cable. Completely unroll extension cables. Avoid electrical
overload.
•Before carrying out maintenance, care or repair work on
the device, remove the mains plug from the mains socket.
Hold onto the mains plug while doing so.
•Disconnect the power cable from the mains socket when
the device is not in use.
•Do not under any circumstances use the device if you
detect damages on the mains plug or power cable.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Defective power cables pose a serious health risk!
•Observe the storage and operating conditions as given in
the Technical data chapter.
•Make sure that the air inlet and outlet are not obstructed.
•Make sure that the suction side is kept free of dirt and
loose objects.
•Do not remove any safety signs, stickers or labels from the
device. Keep all safety signs, stickers and labels in legible
condition.
•Only transport the device in an upright position with an
emptied condensation tank or drain hose.
•Discharge the collected condensate before transport and
storage. Do not drink it. Health hazard!
Intended use
Only use the device as a stationary industrial dryer for drying
and dehumidifying room air whilst adhering to the technical
data and safety instructions.
Intended use comprises:
•drying and dehumidifying:
– production plants, underground rooms
– store rooms, archives, laboratories
– rooms and areas after water damage caused by burst
pipes or flooding
•keeping dry of:
– instruments, devices, files
– electrical control centres
– moisture-sensitive goods, loads, etc.
Improper use
•Do not place the device on wet or flooded ground.
•Do not place any objects, e.g. clothing, on the device.
•Do not use the device outdoors.
•Any unauthorised modifications, alterations or structural
changes to the device are forbidden.
•Any operation other than as described in this manual is
prohibited. Non-observance renders all claims for liability
and guarantee null and void.
Personnel qualifications
People who use this device must:
•be aware of the dangers that occur when working with
electric devices in damp areas.
•have read and understood the instructions, especially the
Safety chapter.
Maintenance tasks which require the housing to be opened
must only be carried out by specialist companies for cooling and
air-conditioning or by Trotec.
EN3
dehumidifier DH 15 / DH 30 / DH 60
Residual risks
Warning of electrical voltage
Work on the electrical components must only be
carried out by an authorised specialist company!
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning
Dangers can occur at the device when it is used by
untrained people in an unprofessional or improper way!
Observe the personnel qualifications!
Warning
A falling device can cause injuries! Always transport
and assemble the device with the help of other
persons. Never stand below the device when it is
suspended. Ensure adequate stability of the device's
wall fixing.
Warning
The device is not a toy and does not belong in the
hands of children.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Behaviour in the event of an emergency
1. In an emergency, disconnect the device from the mains
feed-in: Hold onto the mains plug while pulling the power
cable out of the mains socket.
2. Do not reconnect a defective device to the mains.
Information about the device
Description of the device
The dehumidifiers of the DH series uses the principle of
condensation to automatically dehumidify rooms.
The fan sucks damp room air through the air inlet, the
evaporator and the condenser located behind it. The air is
cooled at the cold evaporator until it is below the dew point.
Water vapour contained in the room air precipitates on the
evaporator fins as condensation or rime. The dehumidified,
cooled air is rewarmed at the condenser and blown out at a
temperature of approx. 5°C above room temperature.
The drier air, thus conditioned, mixes with the air in the room
via the air outlet. The humidity in the room where the device is
positioned is reduced as air constantly circulates through the
device. Depending on the air temperature and the relative
humidity, the condensed water either drops continuously or only
during the defrost phase through the pre-assembled
condensation drain hose and is discharged from the device.
To set the desired humidity level, a hygrostat with control dial is
provided in the device's interior. This control dial can be easily
accessed once the housing has been removed.
The device can reduce the relative humidity of a room to
approx. 30%.
Because of the heat radiation generated during operation, the
room temperature may rise slightly.
A high humidity level in the air (starting at 70%RH) provides
the perfect breeding ground for mould. However, the room air
must not be too dry either (<40%RH). Materials such as
leather or rubber become porous, and wood becomes brittle and
fissured.
(tamper-proof installation inside the device)
6Wall holder
7Suspension
8MODEswitch
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Always utilize the help of another person to transport the
DH15/ DH30. Always utilize the help of two other persons to
transport the DH60. Do not try to transport the device without
the help of another person. To lift the device, use a forklift or an
elevating truck as appropriate.
Before transporting the device, observe the following:
•Hold onto the mains plug while pulling the power cable out
of the mains socket.
•Do not use the power cable to drag the device.
•Drain the remaining condensate from the device.
After transporting the device, observe the following:
•Set up the device in an upright position after transport.
•After having transported the device in horizontal position,
leave the device to rest for 12to24hours, so the
refrigerant can accumulate within the compressor. Wait
12to24hours before switching the device back on! Acting
contrary might lead to compressor damage and a
malfunctioning device. Any warranty claims will be voided
in this case.
EN5
dehumidifier DH 15 / DH 30 / DH 60
Storage
C
C
A
B
D
I.III.II.
Before storing the device, proceed as follows:
•Drain the remaining condensate from the device.
•Hold onto the mains plug while pulling the power cable out
of the mains socket.
When the device is not being used, observe the following
storage conditions:
•dry and protected from frost and heat
•in an upright position where it is protected from dust and
direct sunlight
•with a cover to protect it from invasive dust, if necessary
•Place no further devices or objects on top of the device to
prevent it from being damaged.
Assembly and installation
Scope of delivery
•1x Device
•1x Wall holder
•1x Condensation drain hose, 10mm diameter
•1x Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
•When assembling the device, observe the minimum
distance from adjacent walls or other objects as described
in the Technical Data chapter.
Assemble the device as follows:
Select screw and wall plug sizes suitable for the weight of the
device (see technical data) and the structure of the wall.
DH15
1. Mark the position for the bore holes.
2. Drill the holes into the wall.
3. Insert suitable wall plugs into the drill holes.
Assembly
Always utilize the help of another person to assemble the
DH15/ DH30. Always utilize the help of two other persons to
assemble the DH60. Do not try to assemble the device without
the help of another person. To lift the device, use a forklift or an
elevating truck as appropriate.
Observe the following instructions:
•When assembling the device, keep a sufficient distance to
heat sources.
•When assembling the device, especially in wet areas,
secure the device locally with an RCD (Residual Current
protective Device) which complies with the relevant
regulations.
•Make sure that extension cables are unrolled completely.
•Insert the mains plug into a properly secured mains
socket.
6EN
dehumidifier DH 15 / DH 30 / DH 60
4. Remove the housing.
5
Ø = 11 mm
5. Screw the support rail and the device to the wall.
7. Check whether the condensation drain hose is positioned
correctly. The condensation drain hose must not be
kinked.
8. Put the housing back on the device.
6. Set the control dial(5) to the desired humidity level.
EN7
dehumidifier DH 15 / DH 30 / DH 60
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.