Tronicc Technologies E01A User Manual

Multifunctional Wallet

Tronicc Technologies

1) Operation Instruction

1. Charge the wallet:

Plug the USB cable to the microUSB port on the wallet to start
charging, the wallet will beep and the led light will start to blink. Press
button once to stop the led blink and press another time to recover
the blink.

2. Charge the phone:

Plug the short cable on the wallet to the phone, and press button
once to start charging. The wallet will beep and the led light will start
to blink. Press button once to stop the led blink and press another
time to recover the blink.

3. Connect the wallet to the phone:

Open Android app or iOS app. If it’s the first time the app is opened, it
will prompt to register a wallet to the phone. Press “Continue” the app
will start to connect to the wallet it finds, then press the button on the
wallet for 3 times to finish the registration.
If the app finds a register wallet when it’s opened, it will start to
connect to the wallet.

4. Call the phone from the wallet:

When the phone and wallet are connected, press the button on wallet
3 times the phone will play a sound. Press the button on wallet 3
times again the sound will stop.

5. Call the wallet from the phone:

When the phone and wallet are connected, press call wallet button on
app once, the wallet will play a sound. Press the button another time,
the sound will stop.

FCC Warning：

This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.

Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.