Tripp Lite SR4POST User Manual
MODEL: SR4POST
ADJUSTABLE OPEN RACK
Assembly Instructions
Contents
1 -Base (2 Pcs.)1 -Base (2 Pcs.)
2 -Post (4 Pcs.)2 -Post (4 Pcs.)
3 -Side lower members (4 Pcs.)3 -Side lower members (4 Pcs.)
4 -Center lower members (2 Pcs.)4 -Center lower members (2 Pcs.)
5 -Side upper members (4 Pcs.) 5 -Side upper members (4 Pcs.)
6 -Center upper members (2 Pcs.)6 -Center upper members (2 Pcs.)
7- Top support bracket (2 Pcs.)7- Top support bracket (2 Pcs.)
Assembly hardware
3/8¨-16 UNF hex nut (32 Pcs.)3/8¨-16 UNF hex nut (32 Pcs.)
3/8¨X 7/8¨ Spring washer (32 Pcs.) 3/8¨X 7/8¨ Spring washer (32 Pcs.)
3/8¨-16x1¨UNF screw (32 Pcs.)3/8¨-16x1¨UNF screw (32 Pcs.)
Required Tools
9/16¨ Wrench9/16¨ Wrench 9/16¨ Socket, Ratchet9/16¨ Socket, Ratchet
Assemble Base & Posts
1 1
* Place base on a hard flat surface. Use 3/8¨
Screws to attach base to each post
7 7
2 2
1 1
5 5
6 6
3 3
* Equipment Hardware
4 4
12-24 X 5/8”Cilindrycal head screw (56 Pcs.)
PVC black flat washer (56 Pcs.)
12-24X5/8” Conical screw washer (56 Pcs.)
PVC White flat washer (56 Pcs.)
(32 Pcs w/mounting fasteners)
Install Pre-Assembled upper
4 4
side members as shown
*Use included nuts .Fasten tightly
12-24 x 5/8 Screw (56 Pcs.)
Cable manager hooks...
1A. repeat for rear side
Assemble top support bracket
2 2
* Verify alignment
2A. repeat for rear side
Pre-Assemble upper and lower
3 3
side memebers
* Set desired depth
Use 3/8¨Screws and tighten members
4
2
4
2
Install Pre-Assembled lower side
5 5
members as shown
* Verify alignment before tightening
Install Cable Manager Hooks as desired
6 6
* Use included plastic fasteners
1111 W. 35th St, Chicago, IL 60609
(773) 869-1234 www.tripplite.com
Loading...