Tripp Lite Power Accessory Module PAM-3 Instruction Sheet

1111 W.35th Street

Chicago, IL 60609 USA

Customer Support: [phone]

www.tripplite.com

Instruction Sheet

PAM-3

Power Accessory Module

The PAM-3 Power Accessory Module provides a wide variety of electrical outlets for the output of a
Tripp Lite UPS system. The PAM-3 may be hardwired to the output of a Unison SmartOnLine

®

SU6K or SU10K.

Safety:

• The PAM-3 features both 120V and 208/240V outlets. Make sure to connect equipment to
receptacles of the correct voltage.

• A total load of 30 amps can be drawn from the PAM-3. When connecting equipment,
take care not to exceed this current rating.

Connecting a PAM-3 to the Output of a SmartPro
DataCenter or PAM-1

• Simply plug your PAM-3's NEMA L14-30P plug into the NEMA L14-30R output
receptacle on the rear of your SmartPro DataCenter unit or on the front of your PAM-1.

Copyright © 2000 Tripp Lite. All rights reserved.

Unison SmartOnLine®and SmartPro DataCenter®are registered trademarks of Tripp Lite.

Connecting a PAM-3 to the Output of a Unison SU6K
or SU10K

WARNING: Before connection, make sure that your Unison system is OFF, that both input
and output breakers are switched OFF and that the system is not connected to AC power.

(See Unison Owner's Manual.)

• Remove the PAM-3's input plug by loosening its strain relief, unscrewing and removing
the plug's housing, detaching the power cord's four internal colored wires from their
terminals and sliding off the plug.

• Strip an additional 1" to 2" of the outer (black) casing of the power cord away from the
internal colored wires. Neatly shape the exposed metal ends of the four colored wires
to eliminate loose strands.

• Slip the strain relief provided over the exposed end of the power cord, then thread the
exposed end of the power cord through the knockout nearest the right of the Unison's
terminal block.

• Connect the colored wires to the Unison's terminal block as shown below. The black
cord can be connected for either 240V output or 208V output. Note: the desired output
voltage MUST match the Unison's input voltage. (See Unison Owner's Manual.)

• Tighten the strain relief and affix it to the knockout.

(Note: This diagram shows the terminal block of a SU6kVA model. SU10kVA models have double connectors, but the wires are
attached to the same terminals on both models.)

®

Black
208 V

Black
240 V

Green

White

Red

93-1844 (200006177) 7/00