Tripp-Lite OMNISMART350HG Specifications

OmniSmart 120V 330VA 225W UL 60601-1 Medical

Highlights

330VA line interactive tower UPS

Maintains sine-wave 120V

nominal output over an input

range of 83 to 132V

Professional features include

serial port, hospital grade plug &

outlets, built-in isolation

transformer and UL60601-1 listing

Input: Hospital-grade NEMA

5-15P (120V 15A) / Output: 4

Hospital-grade NEMA 5-15R

(120V)

2 line phone suppression for

TEL/DSL line protection

Leakage current less than 100

microamps

Package Includes

OMNI SMART 350HG Hospital

Grade UPS System

Serial cable for remote monitoring

Warranty information

Instruction manual

Grade Line-Interactive UPS, Tower, DB9 Serial

MODEL NUMBER: OMNISMART350HG

Description

Tripp Lite's OMNI SMART 350HG offers medical-grade UPS protection with built-in line interactive voltage

regulation, intelligent monitoring and unattended shutdown capability. Hospital-grade plug & outlets, plus built-in

isolation transformer with Faraday shield offers full isolation and removes common mode noise equal to 100

microamps. UL 60601-1 listed as medical electrical equipment. 330VA power handling capacity supports

computers, inter-networking equipment and other critical loads during commercial power failures. Line interactive

voltage regulation corrects brownouts as low as 83V back to normal 120V levels, saving battery reserves for use only during complete power failures. Includes,

2 line phone surge suppression and built-in DB-9 communications port that works with PowerAlert Software and cabling to provide automatic unattended

shutdown of connected network and PC applications.

Features

Ideal UPS protection for applications in medical patient-care areas where UL 60601-1 listed electrical medical equipment is required

Line-interactive voltage regulation corrects brownouts as low as 83V without using battery power

Hospital-grade plug and outlets offer added degree of safety and reliability to input/output connections

Full line isolation prevents shock potential and operational problems in sensitive electronic equipment

Resistant to electrostatic discharge

Supports loads up to 330VA/225 watts

46 minutes half load runtime (with 165VA load), 18 minutes full load runtime (with 330VA load)

4 protected hospital-grade outlets; 6-ft. cord

1-DB9 serial port for network interface

Complete surge protection, line isolation and EMI/RFI noise filtering

2 phone line surge suppression for modems, fax machines and other phone accessories

Complete remote monitoring cabling included, PowerAlert UPS management software available via free download

4 diagnostic LEDs indicate AC present, on battery, voltage correction & battery low/replace

Battery replacement door and back panel grounding lug

Specifications

OUTPUT

Output Volt Amp Capacity (VA) 330

Output Watt Capacity (Watts) 225

Nominal Output Voltage(s)
Supported

Frequency Compatibility 60 Hz

Output Voltage Regulation (Line
Mode)

Output Voltage Regulation (Battery
Mode)

Output Receptacles (4) 5-15R

Output Receptacle Details Hospital grade output receptacles

Output AC Waveform (AC Mode) Sine wave

Output AC Waveform (Battery Mode) PWM sine wave

INPUT

Rated input current (Maximum Load) 2.3A

Nominal Input Voltage(s) Supported 120V AC

UPS Input Connection Type 5-15P-HG

Input Circuit Breakers 3.5A

UPS Input Cord Length (ft.) 6

UPS Input Cord Length (m) 1.8

120V

-18%, +8%

+/- 5%

Recommended Electrical Service 15A 120V

Input Phase Single-Phase

BATTERY

Full Load Runtime (min.) 18 min. (225w)

Half Load Runtime (min.) 46 min. (115w)

DC System Voltage (VDC) 12

Battery Recharge Rate (Included
Batteries)

Internal UPS Replacement Battery
Cartridge

Battery Access Battery access door

Battery Replacement Description Hot-swappable, user replaceable batteries

Less than 4.5 hours from 10% to 90%

(quantity 2)

RBC52