Tripp Lite OMNI1000ISO User Manual

Tripp Lite
1111 West 35th Street
Chicago, IL 60609 USA
Telephone: +(773) 869 1234
E-mail: saleshelp@tripplite.com
Model #: OMNI1000ISO
Highlights
1000VA line interactive UPS with built-in isolation transformer
Maintains 120V nominal output over an input range of 81 to 143V
Built-in USB communications port
Input: NEMA 5-15P (120V 15A) / Output: 6 NEMA 5-15R (120V)
2 year product warranty
Description
Tripp Lite's OMNI1000ISO offers complete UPS protection with built-in line-interactive voltage regulation, intelligent monitoring and unattended
shutdown capability. Built-in isolation transformer with Faraday shield offers full isolation and complete common mode noise rejection. 1000VA
power-handling capacity supports point-of-sale applications, computers, internetworking equipment and home theater systems during commercial
power failures. Line-interactive voltage regulation corrects brownouts as low as 81V and overvoltages as high as 143V back to normal 120V levels,
reserving battery power for use during complete power failures. Built-in USB communications port works with PowerAlert Software and cabling to
provide automatic unattended shutdown of connected network and PC applications.
Applications
Ideal for providing a continuous clean grounding reference, voltage regulation and backup power for sensitive POS, networking and home-theater applications
Package Includes
OMNI1000ISO UPS System USB cable Owner's manual with warranty information
Features
1000VA line-interactive UPS with Faraday-shielded, low-impedance isolation transformer delivers full isolation from potential damage and performance problems Provides immunity from EMI/RFI line noise in both normal and common modes. Delivers clean signal-reference ground, reducing data errors and audio/video distortion Automatic voltage regulation (AVR) automatically corrects incoming voltage to keep equipment working through low voltage (brownouts) as low as 81V and overvoltages as high as 143V without consuming battery power Supports loads up to 1000VA/700W Half-load runtime of 24 min. (500VA/350W); full load runtime of 8 min. (1000VA/700W) 5 diagnostic LEDs indicate AC present, on battery, voltage correction status, overload and battery low/replace Electrostatic discharge (ESD) resistance reduces potential static damage to connected electronics Built-in USB port and PowerAlert Software (free via web download) provide safe, unattended system shutdown during extended blackouts
Built-in surge suppression (backed by $200,000 Ultimate Lifetime Insurance) safeguards connected equipment against damage SURGE VOLTAGE WITHSTAND CAPABILITY: ANSI/IEEE C62.41 Catagories A & B 6KV/200/500 amp 100Khz Ringwave and category B BiWave SURGE VOLTAGE ATTENUATION: N-G 2000:1, L-G 240:1, L-N 100:1 INSERTION LOSS: 65 db N-G from 10Khz to 100Khz, 45 to 60 db L-G from 10Khz to 100Khz, 18 to 54 db L-N from 50Khz to 500 Khz 6 UPS-supported AC outlets; 6-ft. cord 2-year product warranty
Specifications
SYSTEM OVERVIEW
Voltage compatibility 120V
Frequency compatibility
60Hz
OUTPUT
Output VA 1000
Output watts 700
Output nominal voltage
120V (line mode) / 115V (battery mode)
Output voltage regulation
LINE MODE: Sine wave line voltage 120V (-18%/+8%) / BATTERY MODE: 115V (+/-5%)
Output frequency regulation
LINE MODE: Passes line frequency of 60Hz (+/-10%)
Outlet quantity / type 6 NEMA 5-15R
INPUT
Maximum input amps
7.6A at 120V
Input connection type
NEMA 5-15P
Input cord length 6 ft./1.8m
Recommended Electrical Service
15A 120V
BATTERY
Full load runtime 8 min. (700W)
Half load runtime 24 min. (350W)
DC system voltage 36V
Typical battery lifespan
4-6 years (typical)
Battery recharge rate 2-4 hours to 90%
Replacement Battery Cartridge
RBC53
VOLTAGE REGULATION
Voltage regulation description
Line-interactive UPS systems offers two levels of brownout correction and one level of overvoltage correction to maintain usable, computer grade output
Overvoltage correction
Input voltages between 128-143V are reduced by 9%
Brownout correction Input voltages between 96-107V are boosted by 10%
Severe brownout correction
Input voltages between 85-95V are boosted by 20%
LEDS ALARMS & SWITCHES
Front panel LEDs 5 diagnostic LEDs indicate AC present, on battery, voltage correction status, overload and battery low/replace status
Alarms Audible alarm indicates power failure conditions, silenceable via alarm cancel push-button switch. Once cancelled, alarm
will resume when approximately 2 min. of battery operation remain (assuming full load)
Switches 2 front panel push-button switches for system enable, self-test, and alarm cancel functions
SURGE / NOISE SUPPRESSION
AC surge suppression
SURGE VOLTAGE WITHSTAND CAPABILITY: ANSI/IEEE C62.41 Catagories A & B 6KV/200/500 amp 100Khz Ringwave and category B BiWave. SURGE VOLTAGE ATTENUATION: N-G 2000:1, L-G 240:1, L-N 100:1. INSERTION LOSS: 65 db N-G from 10Khz to 100Khz, 45 to 60 db L-G from
AC suppression response time
Instantaneous
Dataline suppression
-
EMI / RFI AC noise suppression
Yes
PHYSICAL
Shipping weight (lbs)
40
Shipping weight (kg) 18
Shipping Dimensions (HWD/in)
18.25 x 12 x 13.75
Shipping Dimensions (HWD/cm)
46.4 x 30.5 x 35
Unit weight (lbs) 36.4
Unit weight (kg) 16.38
Unit Dimensions (HWD/in)
12.75 x 7.5 x 9.25
Unit Dimensions (HWD/cm)
32.4 x 19.05 x 23.5
Material of construction
PVC
Form factors supported
Tower
Cooling method Fan
Battery Access Battery access door
ENVIRONMENTAL
Relative Humidity 0 to 95%, non-condensing
Storage Temperature +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Operating Temperature
+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
COMMUNICATIONS
Network monitoring port
USB
Software and cabling included
USB cable included; Power Alert software available via free download from www.tripplite.com
WatchDog compatibility
Yes, with optional WATCHDOGSW
LINE / BATTERY TRANSFER
Transfer time from line power to battery mode
2-4 milliseconds
Low voltage transfer to battery power
81V (resets to line power as voltage increases above 85V)
High voltage transfer to battery power
143V (resets to line power as voltage decreases to 139V)
SPECIAL FEATURES
Cold Start Inverter can be cold started to enable temporary AC output during a power failure
Appearance Attractive all-black color scheme
CERTIFICATIONS
Certifications Tested to UL1778 (USA), CSA C22.2 No. 107.3 (Canada), Class A (Emissions), NOM (Mexico)
WARRANTY
Product Warranty Period
2 years
Connected Equipment Coverage
$200,000
Optional Coverage 3-year and 5-year extended warranty coverage available (see Options and Accessories section listing)
Related Items
Extended Warranties
WEXT3-OMNI 3-Year Extended Warranty - For OmniSmart, OmniPro, OmniVS Qty: [optional]
WEXT5-OMNI 5-Year Extended Warranty - For OmniSmart, OmniPro, OmniVS Qty: [optional]
Wallmount Bracket
UPSWM Wallmount Bracket and installation accessories (4 washers, 4 screws, 1 Velcro safety strap) Qty: [optional]
More information, including related products, owner's manuals, and additional technical specifications, can be found online at
www.tripplite.com/en/products/model.cfm?txtModelID=3196.
©2009 Tripp Lite. All Rights Reserved.
Loading...